CWB level 1 Exam prep
The welding inspector's role in welding begins:
before welding starts
Prior to welding, the welding inspector should check that the:
approved welding procedures are available and the welders are qualified
Which is not the function of the welding inspector?
Developing a repair procedure
If during a manufacturing inspection, cracking is found on the outside of a pressure vessel weld, the
inspector shall:
record the details of the crack, immediately draw it to the attention of the welding supervisor or the
welder and check that it is repaired in accordance with an authorized repair procedure
The Material Test Report (MTR) is a (an)
important document that provides the owner (and the fabricator) with the ability to identify properly
qualified materials.
, The material test report (MRT)
provides mechanical test results that confirm that the product covered meets the specification.
Reports produced by the welding inspector should be;
neat and accurate
When reviewing a fabricator's ITP on behalf of the client, the welding inspector should:
indicate any hold points so that he may witness specific activities
Which information would be expected on the fabricator's ITP?
The point in the project at which welding starts
Following completion of the welding operation, the welding inspector:
checks that all the required welds have been made
Steels meeting any grade of CAN/CSA-40.21 must also meet the requirements of:
CAN / CSA-40.20
Which information might be found on an MTR (mill test report or certificate)
The welding inspector's role in welding begins:
before welding starts
Prior to welding, the welding inspector should check that the:
approved welding procedures are available and the welders are qualified
Which is not the function of the welding inspector?
Developing a repair procedure
If during a manufacturing inspection, cracking is found on the outside of a pressure vessel weld, the
inspector shall:
record the details of the crack, immediately draw it to the attention of the welding supervisor or the
welder and check that it is repaired in accordance with an authorized repair procedure
The Material Test Report (MTR) is a (an)
important document that provides the owner (and the fabricator) with the ability to identify properly
qualified materials.
, The material test report (MRT)
provides mechanical test results that confirm that the product covered meets the specification.
Reports produced by the welding inspector should be;
neat and accurate
When reviewing a fabricator's ITP on behalf of the client, the welding inspector should:
indicate any hold points so that he may witness specific activities
Which information would be expected on the fabricator's ITP?
The point in the project at which welding starts
Following completion of the welding operation, the welding inspector:
checks that all the required welds have been made
Steels meeting any grade of CAN/CSA-40.21 must also meet the requirements of:
CAN / CSA-40.20
Which information might be found on an MTR (mill test report or certificate)
