Copyright © 2021 Pearson Education, Inc.
dt dt dt dt dt
VERIFIEDBRAINBOOSTER
,Automotive Steering, Suspension, & Alignment, 8e (Halderman) A dt dt dt dt dt dt dt
ppendix 1 dt
1) A customer complains that the steering lacks power assist all the time. Technician A says that th
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
e power steering pump drive belt could be slipping or loose. Technician B says that worn outer tie r
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
od ends could be the cause. Which technician is correct?
dt dt dt dt dt dt dt dt dt
A) Technician A only dt dt
B) Technician B only dt dt
C) Both Technicians A and B dt dt dt dt
D) Neither Technician A nor B dt dt dt dt dt
Answer: A d t
2) A front-wheel-
dt
drive vehicle pulls toward the right during hard acceleration. The most likely cause is
dt dt dt dt dt dt dt dt dt dt dt dt dt dt .
A) worn or defective tires dt dt dt
B) leaking or defective shock absorbers dt dt dt dt
C) normal torque steer dt dt
D) a defective power steering rack-and-
dt dt dt dt
pinion steering assembly Answer: C
dt dt dt d t
3) When replacing a rubber-bonded socket (RBS) tie rod end, the technician should be sure to
dt dt dt dt dt dt dt dt dt dt dt dt dt dt
.
A) remove the original using a special tool dt dt dt dt dt dt
B) install and tighten the replacement with the front wheels in the straight-ahead position
dt dt dt dt dt dt dt dt dt dt dt dt
C) grease the joint before installing on the vehicle
dt dt dt dt dt dt dt
D) install the replacement using a special clamp vise
dt dt dt dt dt dt dt dt
Answer: B d t
4) Whenever installing a tire on a rim, do not exceed dt dt dt dt dt dt dt dt dt dt .
A) 25 PSI dt
B) 30 PSI dt
C) 35 PSI dt
D) 40 PSI dt
Answer: D d t
5) Two technicians are discussing mounting a tire on a wheel. Technician A says that for best bala
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
nce, the tire should be match mounted. Technician B says that silicone spray should be used to lubr
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
icate the tire bend. Which technician is correct?
dt dt dt dt dt dt dt
A) Technician A only dt dt
B) Technician B only dt dt
C) Both Technicians A and B dt dt dt dt
D) Neither Technician A nor B dt dt dt dt dt
Answer: A d t
2
Copyright © 2021 Pearson Education, Inc. dt dt dt dt dt
VERIFIEDBRAINBOOSTER
,6) Technician A says that radial tires should only be rotated front to rear, never side to side. T
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
echnician B says that vehicle manufacturers usually recommend that radial tires should be rot
dt dt dt dt dt dt dt dt dt dt dt dt dt
ated using the modified X method. Which technician is correct?
dt dt dt dt dt dt dt dt dt
A) Technician A only dt dt
B) Technician B only dt dt
C) Both Technicians A and Bdt dt dt dt
D) Neither Technician A nor B dt dt dt dt dt
Answer: B d t
7) For a tire that has excessive radial runout, Technician A says that it should be broken down on a t
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
ire-
changing machine and then rotated 180 degrees on the wheel and retested. Technician B says that t
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
he tire should be replaced. Which technician is correct?
dt dt dt dt dt dt dt dt
A) Technician A only dt dt
B) Technician B only dt dt
C) Both Technicians A and Bdt dt dt dt
D) Neither Technician A nor B dt dt dt dt dt
Answer: A d t
8) Technician A says that overloading a vehicle can cause damage to the wheel bearings. Technici
dt dt dt dt dt dt dt dt dt dt dt dt dt dt
an B says that tapered roller bearings used on a nondrive wheel should be adjusted hand tight only a
dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt dt
fter seating. Which technician is correct?
dt dt dt dt dt
A) Technician A only dt dt
B) Technician B only dt dt
C) Both Technicians A and Bdt dt dt dt
D) Neither Technician A nor B dt dt dt dt dt
Answer: C d t
9) Defective wheel bearings usually sound like dt dt dt dt dt dt .
A) a growl dt
B) a rumble dt
C) snow tires dt
D) All of the above dt dt dt dt
Answer: D d t
10) Defective outer CV joints usually make a clicking noise dt dt dt dt dt dt dt dt dt
A) only when backing dt dt
B) while turning and moving dt dt dt
C) while turning only dt dt
D) during braking dt d
Answer: B
t d t
11) The proper lubricant usually specified for use in a differential is
dt dt dt dt dt dt dt dt dt dt dt .
A) SAE 15-40 engine oil dt dt dt
B) SAE 80W-90 GL-5 dt dt
C) STF
D) SAE 80W-140 GL-1 dt dt
3
Copyright © 2021 Pearson Education, Inc. dt dt dt dt dt
VERIFIEDBRAINBOOSTER
, Answer: B
d t
4
Copyright © 2021 Pearson Education, Inc.
dt dt dt dt dt
VERIFIEDBRAINBOOSTER