VIVINT SMART HOME PRO CERTIFICATION
EXAM 2026 QUESTIONS AND ANSWERS
GRADED A+
◉ The smkt3 has 2 function:smoke and heat detection Answer: False
◉ How would you program a co3 if mounted on a hallway wall
Answer: Loop 1 Zone 14
◉ When installing a translator, you must program all of the existing
sensors as new equipment on the panel Answer: False
◉ The dw21 should always be installed in the door frame Answer:
True
◉ Which of the following zone/sensor types are correct when
programming an smkt3 Answer: (09) Smoke detector. (09) Heat
detector. (08) Freeze
◉ What it the correct height ar which to install the Pir2 Answer: 7ft
◉ When programming a Dw21 what loop number is used Answer:
Loop 2
, ◉ When programming a sensor into a sky control panel, you can
type in the serial number or learn it in by triggering the device.
Answer: True
◉ How would you program a gb2 when it is mounted on a master
bedroom ceiling Answer: Loop 1 Zone 3
◉ Panic pendants are programmed as an audible alarm(type 07)
Answer: True
◉ When installing the take 345 you must ensure that the
transformer is supplying power to the power supply before
connecting the battery Answer: True
◉ When wiring the take 345 you must ensure it has three points of
ground: the low side of each zone, the takeover module, and the
power supply Answer: True
◉ You are required to test all secondary keypads and key fobs even
though they are not detection devices Answer: True
◉ When installing a dw21, what size drill bit should you use to drill
the hole for the sensor Answer: 3/4"
EXAM 2026 QUESTIONS AND ANSWERS
GRADED A+
◉ The smkt3 has 2 function:smoke and heat detection Answer: False
◉ How would you program a co3 if mounted on a hallway wall
Answer: Loop 1 Zone 14
◉ When installing a translator, you must program all of the existing
sensors as new equipment on the panel Answer: False
◉ The dw21 should always be installed in the door frame Answer:
True
◉ Which of the following zone/sensor types are correct when
programming an smkt3 Answer: (09) Smoke detector. (09) Heat
detector. (08) Freeze
◉ What it the correct height ar which to install the Pir2 Answer: 7ft
◉ When programming a Dw21 what loop number is used Answer:
Loop 2
, ◉ When programming a sensor into a sky control panel, you can
type in the serial number or learn it in by triggering the device.
Answer: True
◉ How would you program a gb2 when it is mounted on a master
bedroom ceiling Answer: Loop 1 Zone 3
◉ Panic pendants are programmed as an audible alarm(type 07)
Answer: True
◉ When installing the take 345 you must ensure that the
transformer is supplying power to the power supply before
connecting the battery Answer: True
◉ When wiring the take 345 you must ensure it has three points of
ground: the low side of each zone, the takeover module, and the
power supply Answer: True
◉ You are required to test all secondary keypads and key fobs even
though they are not detection devices Answer: True
◉ When installing a dw21, what size drill bit should you use to drill
the hole for the sensor Answer: 3/4"
