ETCP FINAL EXAM TEST LATEST UPDATE WITH 100%
SOLVED -GRADED A+ VERIFIED 2026 UPDATE
A lighting shop order should primarily include.. - correct answer-
Hardware counts.
AC Power Formula (Single Phase) - correct answer- Watts =
Volts x Amps x Power Factor
AC Power Formula (Three Phase) - correct answer- Watts =
Volts x Amps x Power Factor x 1.732
According to ANSI E1.23-2010 (R2015) Entertainment
Technology - Design and Execution of Theatrical Fog Effects, the
specifics of effects cuing operation, including timing and
duration, should be set by the... - correct answer- Effects
Designer
According to OSHA the correct attachment point for a lanyard
fall-arrest harness is.. - correct answer- Between the
shoulder blades
, According to the ANSI E1.11 USITT DMX512 Standard, which
connectors are specified for DMX512? - correct answer- 5
Pin XLR
Active Load - correct answer- Inductive
An electrician encounters an overheated connector in a long run
of cables. What is the best course of action? - correct answer-
Remove both cables from service and repair them.
An Electrician notices excessive heating on a neutral conductor
on portable distribution equipment feeding the dimmer system.
What will most likely correct the problem? - correct answer-
Over-sizing the neutral conductor
Apparent Power Formula - correct answer- (VA) = V (Volts) x
I (Amps)
Donut - correct answer- Sharpens the focus of a gobo
(pattern) when using an lighting fixture
Dry Ice - correct answer- Low hanging fog effect
SOLVED -GRADED A+ VERIFIED 2026 UPDATE
A lighting shop order should primarily include.. - correct answer-
Hardware counts.
AC Power Formula (Single Phase) - correct answer- Watts =
Volts x Amps x Power Factor
AC Power Formula (Three Phase) - correct answer- Watts =
Volts x Amps x Power Factor x 1.732
According to ANSI E1.23-2010 (R2015) Entertainment
Technology - Design and Execution of Theatrical Fog Effects, the
specifics of effects cuing operation, including timing and
duration, should be set by the... - correct answer- Effects
Designer
According to OSHA the correct attachment point for a lanyard
fall-arrest harness is.. - correct answer- Between the
shoulder blades
, According to the ANSI E1.11 USITT DMX512 Standard, which
connectors are specified for DMX512? - correct answer- 5
Pin XLR
Active Load - correct answer- Inductive
An electrician encounters an overheated connector in a long run
of cables. What is the best course of action? - correct answer-
Remove both cables from service and repair them.
An Electrician notices excessive heating on a neutral conductor
on portable distribution equipment feeding the dimmer system.
What will most likely correct the problem? - correct answer-
Over-sizing the neutral conductor
Apparent Power Formula - correct answer- (VA) = V (Volts) x
I (Amps)
Donut - correct answer- Sharpens the focus of a gobo
(pattern) when using an lighting fixture
Dry Ice - correct answer- Low hanging fog effect
