Advanced Rigging Test Complete Solutions
1. the operational quadrant between the left-or-right-side outriggers is: -
over-the-side
2. cranes are typically built to be: longer than they are wide
3. in a multiple-crane lift, the crane with the greatest net capacity must always be: closest to
the loads center of gravity
4. leverage is defined as: the power applied to a lever to cause the load to move
5. the quadrant that is located between the rear outriggers or crawlers in the rearward
direction of travel is known as: over-the-rear
6. what dynamic occurs when a load is hoisted from a point other than directly over the
load: pendulum ettect
7. the sudden release of a load that causes a rapid change in effective load weight is
called: acceleration
8. backward stability of a crane is affected by: high boom angles and inclines
9. a loads center of gravity in relation to the tipping axis is affected by all of the following
except: raising or lowering the load
10. a cranes stability is affected by all of the following except: centered lift
11. to find the parts of line, the operator: divides the suspended weight by the WLL of the hoist rope
12. a document that outlines all weight, rigging, and configuration requirements for a
1/
4
1. the operational quadrant between the left-or-right-side outriggers is: -
over-the-side
2. cranes are typically built to be: longer than they are wide
3. in a multiple-crane lift, the crane with the greatest net capacity must always be: closest to
the loads center of gravity
4. leverage is defined as: the power applied to a lever to cause the load to move
5. the quadrant that is located between the rear outriggers or crawlers in the rearward
direction of travel is known as: over-the-rear
6. what dynamic occurs when a load is hoisted from a point other than directly over the
load: pendulum ettect
7. the sudden release of a load that causes a rapid change in effective load weight is
called: acceleration
8. backward stability of a crane is affected by: high boom angles and inclines
9. a loads center of gravity in relation to the tipping axis is affected by all of the following
except: raising or lowering the load
10. a cranes stability is affected by all of the following except: centered lift
11. to find the parts of line, the operator: divides the suspended weight by the WLL of the hoist rope
12. a document that outlines all weight, rigging, and configuration requirements for a
1/
4
