FANUC ROBOT CERTIFICATION EXAM QUESTIONS WITH 100% CORRECT SOLUTIONS | GUARANTEED SUCCESS.

FANUC ROBOT CERTIFICATION EXAM QUESTIONS WITH 100% CORRECT SOLUTIONS |
GUARANTEED SUCCESS.




When you turn the teach pendant on: - (answer)It will permit motion control to the operator using the
teach pendant



Things to do to avoid hard-stops and over travels? - (answer)Set Axis Limits



By Pressing SHIFT and the hard key COORD will show - (answer)The "jog" menu



The three ways of determining A user frame - (answer)Direct method, Three point method, Four point
method



In R-j3 series controller how many standards user frame? - (answer)Nine (9)



To define a remote tool center point (RTCP)? - (answer)You use 3 point, 4 point and direct entry



What direction does the robot move in the WORLD Y+ if the robot is mounted on the floor? - (answer)To
your left



What are the two (2) ways to control the robots motion limits and boundaries? - (answer)Dual Check
Safety & Axis Limits



To clear DCS fault you need to press? - (answer)SHIFT + RESET



To correct Singularity you need to move the robot? - (answer)Joint 5(+-) 5 degrees



What are the individual types of jog speed? - (answer)50%, 75%, 100%, FINE, VFINE



You need to depress the position screen to access? - (answer)POSN