BC Owner Builder Actual Exam Newest /BC Owner Builder Authorization
Practice Exam /BC Owner Builder Authorization Preparation With 300 Questions
And Correct Answers With Rationales| Already Graded A+
If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of entry and exit
must be located:
a) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
b) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
c) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - (Correct Answer)-a
If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of entry and exit
must be located:
a) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
b) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
c) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - (Correct Answer)-c
What is the design and construction that prevents
water from ever entering?
, 2
a) Principle of driving rain deterrent
b) Principle of driving rain deflection
c) Principle of rainwater deterrent
d) Principle of rainwater deflection - (Correct Answer)-d
The higher grit number is equivalent to:
a) a finer abrasive, which creates smoother surface
finishes.
b) a finer abrasive, which creates a rougher surface finish.
c) a rougher abrasive, which creates smoother surface
finishes.
d) a rougher abrasive, which creates a rougher surface finish. - (Correct Answer)-a
The vertical height of any flight of stairs shall not exceed
a) 4.5 m or 15 ft
b) 3.7 m or 12 ft
c) 3.5 m or 11.5 ft
d) 2.8 m or 9 ft - (Correct Answer)-b
Extend the ladder at least ____ above the landing platform or the point of support.
a) 1.5 m (5 ft)
b) 2 m (6.3 ft)
c) 1 m (3 ft)
d) .5 m (1.5 ft) - (Correct Answer)-c
, 3
for every four feet in height, the base of the ladder should be moved ___ foot out from the wall
or structure. - (Correct Answer)-1
Use a ___ ratio for setting ladders (approximately 75 degrees) to determine how far out the base
of the ladder should be moved in relation to the height of the ladder against the wall. - (Correct
Answer)-4:1
To be effective, mechanical ventilation systems must be able to
a) Distribute ventilation air to most rooms of the house and exhaust air from kitchens,
bathrooms, and laundry rooms.
b) Exhaust air from kitchens, bathrooms, and laundry rooms.
c) Distribute ventilation air to bedrooms and common spaces
d) Distribute ventilation air to most bedrooms and exhaust air from bathrooms and laundry
rooms. - (Correct Answer)-a
____________ performs routine remote and physical inspections on gas work and gas equipment
in commercial, industrial, and residential premises.
a) Worksafe BC
b) Regional District Building Inspectors
c) Technical Safety BC - (Correct Answer)-c
If your property is in Technical Safety BC jurisdiction, homeowners can apply for an electrical
homeowner permit.
T or F? - (Correct Answer)-T
Shingles should overlap the valley lining by at least ____
a) 12 inches.
b) 6 inches.
, 4
c) 2 inches.
d) 5 inches. - (Correct Answer)-b
The moisture trapped within the membranes will form bubbles on the surface of the flat roof. As
moisture builds up on the roof, the bubbles will eventually grow and pop, forming a blister. The
moisture is formed by ___________
a) excessive heat and poor attic ventilation.
b) excessive cold and poor attic ventilation.
c) excessive heat and excessive attic ventilation.
d) excessive cold and excessive attic ventilation. - (Correct Answer)-a
If any condensation forms on the inside of your skylight, the weep holes allow the water to drain
out of your home. The condensation can end up dripping into your home instead if ____
a) too many holes are present.
b) these holes are not properly caulked.
c) these holes are blocked by debris.
d) the holes are installed on the downward slope - (Correct Answer)-c
The weep holes in skylights allow the _______
a) air exchange
b) water to drain out of your home
c) condensation to get trapped
d) caulking to adhere the skylight tightly to the mount - (Correct Answer)-b
The depth of a concrete slab control joint should be equal to ______
a) one eighth of the thickness of the slab.
Practice Exam /BC Owner Builder Authorization Preparation With 300 Questions
And Correct Answers With Rationales| Already Graded A+
If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of entry and exit
must be located:
a) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
b) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
c) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - (Correct Answer)-a
If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of entry and exit
must be located:
a) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
b) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to the
entry and exit location.
c) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - (Correct Answer)-c
What is the design and construction that prevents
water from ever entering?
, 2
a) Principle of driving rain deterrent
b) Principle of driving rain deflection
c) Principle of rainwater deterrent
d) Principle of rainwater deflection - (Correct Answer)-d
The higher grit number is equivalent to:
a) a finer abrasive, which creates smoother surface
finishes.
b) a finer abrasive, which creates a rougher surface finish.
c) a rougher abrasive, which creates smoother surface
finishes.
d) a rougher abrasive, which creates a rougher surface finish. - (Correct Answer)-a
The vertical height of any flight of stairs shall not exceed
a) 4.5 m or 15 ft
b) 3.7 m or 12 ft
c) 3.5 m or 11.5 ft
d) 2.8 m or 9 ft - (Correct Answer)-b
Extend the ladder at least ____ above the landing platform or the point of support.
a) 1.5 m (5 ft)
b) 2 m (6.3 ft)
c) 1 m (3 ft)
d) .5 m (1.5 ft) - (Correct Answer)-c
, 3
for every four feet in height, the base of the ladder should be moved ___ foot out from the wall
or structure. - (Correct Answer)-1
Use a ___ ratio for setting ladders (approximately 75 degrees) to determine how far out the base
of the ladder should be moved in relation to the height of the ladder against the wall. - (Correct
Answer)-4:1
To be effective, mechanical ventilation systems must be able to
a) Distribute ventilation air to most rooms of the house and exhaust air from kitchens,
bathrooms, and laundry rooms.
b) Exhaust air from kitchens, bathrooms, and laundry rooms.
c) Distribute ventilation air to bedrooms and common spaces
d) Distribute ventilation air to most bedrooms and exhaust air from bathrooms and laundry
rooms. - (Correct Answer)-a
____________ performs routine remote and physical inspections on gas work and gas equipment
in commercial, industrial, and residential premises.
a) Worksafe BC
b) Regional District Building Inspectors
c) Technical Safety BC - (Correct Answer)-c
If your property is in Technical Safety BC jurisdiction, homeowners can apply for an electrical
homeowner permit.
T or F? - (Correct Answer)-T
Shingles should overlap the valley lining by at least ____
a) 12 inches.
b) 6 inches.
, 4
c) 2 inches.
d) 5 inches. - (Correct Answer)-b
The moisture trapped within the membranes will form bubbles on the surface of the flat roof. As
moisture builds up on the roof, the bubbles will eventually grow and pop, forming a blister. The
moisture is formed by ___________
a) excessive heat and poor attic ventilation.
b) excessive cold and poor attic ventilation.
c) excessive heat and excessive attic ventilation.
d) excessive cold and excessive attic ventilation. - (Correct Answer)-a
If any condensation forms on the inside of your skylight, the weep holes allow the water to drain
out of your home. The condensation can end up dripping into your home instead if ____
a) too many holes are present.
b) these holes are not properly caulked.
c) these holes are blocked by debris.
d) the holes are installed on the downward slope - (Correct Answer)-c
The weep holes in skylights allow the _______
a) air exchange
b) water to drain out of your home
c) condensation to get trapped
d) caulking to adhere the skylight tightly to the mount - (Correct Answer)-b
The depth of a concrete slab control joint should be equal to ______
a) one eighth of the thickness of the slab.
