Best Grades | Must Pass | Latest Update | Correct Answers | 2024/ 2025
NEIEP 800 Final Questions and Correct
Answers | Latest Update
Hydro elevators in low rise applications do not need an room.
overhead machine
Some advantages of hydros are lower equipment and building construction costs because the
load of a hydro is carried to the where as the load of a traction car is carried by the
.
ground, building structure
When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove
the drill stem and bit and use a .
Spider Bob
To plumb the hole, a spider bob is attached to a length of piano wire suspended from as near
as possible to the top of the or from a fixed point on the drill rig.
Hoistway
When welding a joint, lay inch tack welds degrees apart, shift it 90 degrees
and lay two more 1 inch tack welds 180 degrees apart.
1, 180
On power units having the motor beneath the tank, the pump may be either driven or
coupled.
belt, direct
for inquiry mail me @
, Best Grades | Must Pass | Latest Update | Correct Answers | 2024/ 2025
The purpose of the / is to silence the effect of any pulsations in the pump output
and should be as close to the pump as possible.
silencer, muffler
On Bolsters/Bolster Assembly, the plunger is fastened to the which is then
mounted to the center of the Bolster Assembly.
platen plate
With wye-delta, reduced current starting is accomplished without the need for .
resistors
run buttons should run the platform and sling at leveling speeds only.
Temporary
A consists of a piston held closed by an adjustable spring and must open at a
certain pressure to prevent any further increase in pressure.
relief valve
A lowering valve allows the car to be lowered at a speed not exceeding 20fpm in
case of power failure.
manual
As the oil temperature changes, the will change as well and will effect the
performance, more specifically, the leveling and approach of the elevator.
for inquiry mail me @
NEIEP 800 Final Questions and Correct
Answers | Latest Update
Hydro elevators in low rise applications do not need an room.
overhead machine
Some advantages of hydros are lower equipment and building construction costs because the
load of a hydro is carried to the where as the load of a traction car is carried by the
.
ground, building structure
When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove
the drill stem and bit and use a .
Spider Bob
To plumb the hole, a spider bob is attached to a length of piano wire suspended from as near
as possible to the top of the or from a fixed point on the drill rig.
Hoistway
When welding a joint, lay inch tack welds degrees apart, shift it 90 degrees
and lay two more 1 inch tack welds 180 degrees apart.
1, 180
On power units having the motor beneath the tank, the pump may be either driven or
coupled.
belt, direct
for inquiry mail me @
, Best Grades | Must Pass | Latest Update | Correct Answers | 2024/ 2025
The purpose of the / is to silence the effect of any pulsations in the pump output
and should be as close to the pump as possible.
silencer, muffler
On Bolsters/Bolster Assembly, the plunger is fastened to the which is then
mounted to the center of the Bolster Assembly.
platen plate
With wye-delta, reduced current starting is accomplished without the need for .
resistors
run buttons should run the platform and sling at leveling speeds only.
Temporary
A consists of a piston held closed by an adjustable spring and must open at a
certain pressure to prevent any further increase in pressure.
relief valve
A lowering valve allows the car to be lowered at a speed not exceeding 20fpm in
case of power failure.
manual
As the oil temperature changes, the will change as well and will effect the
performance, more specifically, the leveling and approach of the elevator.
for inquiry mail me @
