NCCCO PT Exam 2026/2027 Updated Verified Questions and Solutions A+ Pass Guaranteed

NCCCO PT Exam 2026/2027
Updated Verified Questions
and Solutions A+ Pass
Guaranteed
1. Which unsafe condition could result when a wedge socket is

attached directly to a load hook, using 6x19 IWRC?

(A) Spinning of the load (B) Decreased line pull (C) Decreased

safe working load (D) Structural failure

- ANS - (A) Spinning of the load




2. Which if the following will indicates intemal damage or ultimately

core failure in rotation- resistant rope?

(A) Strand bird caging (B) Dianeter reduction (C) Excessive

lubrication (D) Kinking

- ANS - (B) Dianeter reduction




3. When a jib is erected from the stowed position and not used, how

will its effective weight change?

, (A) It decreases (B) It increases (C) It will tip the crane (D) It stays

the same

- ANS - (B) It increases




4. (45.When operating a telescopic boom crane equipped with an anti

two-block prevention device, which hydraulic functions are

disabled when the device is activated? (A) Winch down, boom up,

and retract the boom. (B) Swing, Winch down, and raise the boom.

(C) Hoist, extend the boom, and lower the boom. (D) Outrigger

controls, retract the boom, and swing.

- ANS - (C) Hoist, extend the boom, and lower the boom.




5. 46. A load applied at an angle to the vertical plane of the boom

describes: (A) Over loading (B) Side loading (C) Static loading (D)

Angle loading

- ANS - (B) Side loading




6. 48. Hand signals must be posted conspicuously: (A) In the vicinity

of hoisting operations B. In the drivers cab of the crane (C) In the

office. (D) In the load chart

- ANS - (A) In the vicinity of hoisting operations

,7. Which crane hand signal is illustrated? (A) Retract the boom (B)

Raise the boom (C) Extend the boom (D) Lower the boom

- ANS - (C) Extend the boom the




8. Power lines would be a big concern when considering a crane's set

up location, another big concern could be? (A) Radio

communication with signal person (B) Capacity of the crane (C)

Gang members, crack heads, & tweakers (D) Voids, tanks, loose fill,

& depressions

- ANS - (D) Voids, tanks, loose fill, & depressions




9. 43. When inspecting the boom on a telescopic boom crane which

item should be inspected? (A) Float pads (B) Wear pads (C)

Counterweight (D) Load block sheaves

- ANS - (B) Wear pads Counterweight




(A) when it's reeved over the main boom tip (B) when it's reeved

over the auxiliary boom head (C) when it's on top of the

boom (D) when it's reeved over the jib

- ANS - C

, 10. 45. When a crane operator leaves the crane, the operator

must first: (A) Disengage the PTO (B) Tum the engine off (C) Land all

suspended loads (D) Secure the area and lock out the controls.

- ANS - C




11. 46. Cranes operating with long booms should be most

concerned with winds coming from the: (A) Rear of the boom (B)

Side of the Boom (C) East (D) South.

- ANS - (B)




12. 47. According to OSHA 1926 Subpart CC which of the

following is prohibited with wire rope on a crane? (A) Splicing (B)

Cutting (C) Severing (D) Lubricating

- ANS - (A)




13. 38. If a crane is not set-up level and the operator swings a

load from the high side to low side, the load radius will: (A)

Increase (B) Decrease (C) Stay the same (D), Increase two feet for

every one-degree out of level

- ANS - (A)