AMPP CIP Level 2 Exams Study Questions with 100% Verified Answers

AMPP CIP Level 2 Exams Study Questions with 100% Verified Answers 1. You have taken an assignment as the coating inspector on a pipeline being installed in your locality. The mainline sections of the pipe already been coated in the fabrication facility. To ensure the field join coatings are properly applied you will need to know: - ANSWER • What mainline coating was originally applied • What field joint coating is specified 2. Which coating is in limited use due to environmental and exposure concerns? - ANSWER Coal Tar Epoxy (CTE) 3. What is the most common application method for Petrolatum (wax) tape on a pipeline? - ANSWER Hand 4. Inspection considerations for heat-shrink sleeves include what? - ANSWER • Ensure the sleeve is in full contact with the pipe • Ensure there is adhesive flow-out beyond the sleeve edge • Holiday detection at proper voltage 5. You are the coating inspector on a pipeline project where field applied foam will be used for insulation. Which of the following are quality concerns regarding the cutback? - ANSWER • Squared cutback edges • Minimum overlap at joints 6. Special substrates that can have tightly adherent oxide films include: - ANSWER • Stainless Steel • Nickel • Tin • Cadmium 7. ASTM D 1730 - ANSWER Preparation of Aluminum and Aluminum Alloy Surfaces for Painting 8. ASTM D 1731 - ANSWER Preparation of Hot Dip Aluminum Surfaces for Painting 9. ASTM D 1732 - ANSWER Preparation of Magnesium Surfaces for Painting 10. SSPC-SP 16 - ANSWER Brush-Off Blast Cleaning of Coated and Uncoated Galvanized Steel, Stainless Steel, and Non-Ferrous Metals 11. You are a coating inspector on a project where stainless steel is the substrate. What challenges should you anticipate in the process? - ANSWER • A smooth surface that needs to be abraded • Dirt, oil or grease • A protective oxide 12. On which substrate would you expect to encounter a tightly adherent oxide film? - ANSWER Anodized Aluminum 13. What substrates should be protected from contact with highly alkaline materials? - ANSWER • Zinc • Aluminum • Lead 14. What are some of the primary reasons for coating wood? - ANSWER • Decoration • Flame retarding • Sealing 15. In regards to maintenance work, remember, all parties should agree on : - ANSWER • Spot repair requirement's • Feathering • Appearance of repaired areas 16. Low-Pressure Water Cleaning (LP WC) - ANSWER - Below 5,000 psig - Also called "power washing" or "pressure washing" 17. High-Pressure Water Cleaning (HP WC) - ANSWER - 5,000 to 10,000 psig 18. High-Pressure Water jetting (HP WJ) - ANSWER - 10,000 to 30,000 psig 19. Ultrahigh-Pressure Water jetting (UHP WJ) - ANSWER - 30,000 psig and above 20. ASTM D 2240 - ANSWER Standard Test Method for Rubber Property- Durometer Hardness 21. ASTM 3363 - ANSWER Pencil hardness test 22. ASTM D 2583 - ANSWER standard test method for indentation hardness of rigid plastics by means of a Barco Impresser 23. ASTM D 4138 (method A) - ANSWER Standard for a Tooke Gauge