1C Hoisting Exam Questions With 100% Correct Answers | Latest Updated 2026 | Guaranteed Pass

1C Hoisting Exam Questions With 100% Correct Answers | Latest Updated 2026 | Guaranteed Pass Single most important safety factor of operation - answer-Operator Accidents happen because - answer-Use with known defect, unsafe route, unsafe loads, unsafe operating techniques When is it safe to operate forklift outside of drivers' seat - answer-Never Bystanders within danger range of machine - answer-Operator's responsibility Essential for safe operation - answer-Smooth turns, starts and stops Feathering - answer-Move load slowly Defect found on machine - answer-Contact supervisor Bystanders in danger zone with raised load - answer-Sound horn and ask them to move Pivot point of forklift - answer-Front axle Teeter totter - answer-Leverage Safe load limits on specific forklifts - answer-Should never be exceededForks pick up load - answer-Center of gravity moves forward Forward tipping happens when - answer-Center of gravity is on the opposite side of the front axle Momentum is created by - answer-Starting, stopping and turning Stability is affected by - answer-weight distribution, axle length, and wheel base Dangers increase as forklift is raised - answer-Tipping, loss of steering, momentum What force causes the forklift to tip forward when brakes are hit - answer-Momentum Center of gravity goes beyond stability area - answer-Tipping Forks in front - answer-Can't keep machine from tipping backwards Lift load straight up and down - answer-Mast Forklift Steering capacity for high speeds on highways - answer-Front wheels fixed, rear wheels steer Short turning radius at high speeds can overturn machine from - answer-Momentum When is it ok to carry riders during operation of machine - answer-Never When forklift tips forward - answer-You lose all steering Up/Down ramp keep forks where - answer-Down the rampRear wheel drive is used because - answer-Both ends spin when turned, load can fall off if turned too fast, causing machine to act differently than cars Don't start a forklift unless - answer-The controls are in neutral, hand brake is set, you are in driver's seat Reverse gear used to stop or start? - answer-NEVER What determines how fast the hydraulic system should move - answer-The distance the controls are moved and the engine speed Jerky movements can be avoided by - answer-Feathering Leak - answer-Notify supervisor, lower load, shut off engine Job site conditions - answer-Determine safe speed of operations Load obstructing view - answer-Drive in reverse When crossing rough terrain or rail road tracks - answer-Cross diagonally Travelling down a slope (save brakes) - answer-Travel down in the same gear used to travel up Travelling on a slope - answer-No turns, approach head on straight, don't travel crosswise Travelling on hollow floors - answer-Weight of load and forklift, load capacity of floor Approaching another vehicle/machine - answer-Sound horn and stop Blind corners - answer-Stop, sound horn, proceed slowlyRated capacity is found - answer-In owner's manual and on load chart Is it safe to exceed load limit? - answer-Nopers, can cause forward tipping, loss of steering, center of gravity to go too far forward Pick up load if - answer-Within limits of landing point, rated capacity, made up with several small, tied parts and banded together securely FALSE before you pick up load - answer-FALSE tilt back forks Max stability at - answer-Forks are inserted all the way back against the backrest Carrying load on fork tips - answer-Cause unwanted counterweight in front, unstable, load may fall Overcapacity loads can be lifted - answer-Never FALSE carrying a load low - answer-FALSE increases jolt on rough terrain Driving in reverse requires - answer-More reaction time since everything is backwards Stability of load when unloading - answer-Just as important as when being carried Forklifts and cars - answer-Keep to the right, stay at least 20ft behind everything Getting close to load placement - answer-Proceed slowly