PC STUDY GUIDE | 156 QUESTIONS AND ANSWERS |
2026 UPDATE | WITH COMPLETE SOLUTION
What is the publication utilized to perform a turnaround inspection? Answer -
A1-V22-MRC-100
How long is a TA good for? Answer - 24 hours
Aside from time what can invalidate a turnaround inspection? Answer - TA
expires once aircraft is weight off wheels or maintenance other than servicing
is completed
What is the publication utilized for a daily inspection? Answer - A1-V22-MRC-
200
How long is a daily good for? Answer - 72 hours
What is the approximate time that is takes to complete a daily inspection
Answer - 3.5 hours
What method can you use to expedite a daily Answer - Adding more PC
How are corrosion inspection requirements identified in the daily cards?
Answer - There will be a "C" in the CRN column next to the step that have
corrosion inspection requirements
,Who are the three signers on the "A" sheet? Answer - PC, Safe for flight, and
Pilot
What is the SSS for the fuel sample kit pre-operational inspection? Answer -
SSS: 15AH
How long are fuel samples good for? Answer - 24 hours
What are the primary responsibilities of a plane captain outlined in the NAMP?
Answer - - Maintain currency and practical proficiency in all areas covered in
the PC training syllabus
- Closely supervise the training of assigned plane captain trainees.
What is ERAC? IRAC? Answer - Electronic rapid action change/ interim rapid
action change
What components are serviced with DOD-L-85734 Answer - T- TAGB
E- ELS
M- MWGB
P- PRGB
C- CFG
What is the minimum/ maximum PSI for pressure refueling the CMV-22?
Answer - 35-55 PSI
What is the hand signal for fire? Answer - Point at affected area and make a
large figure eight with other hand
, What happens when T-handles are armed? Answer - -Arms the appropriate
engines extinguishing fire bottles
-Shuts off fuel to the affected engine
-Removes back-up FADEC power
-Removes hyd pressure to EAPS blowers
-Closes fire doors
What do you have to do prior to and during pressure fueling and refueling?
why? Answer - Depress climb/dive valve poppet on the LFS, RFS, and RAS to
drain any trapped fuel in sponson vent system
Can you defuel on APU? Answer - No
What do you use to defuel? Answer - External power source
What is the PRGB and TAGB oil pressure Answer - 60-95 psi
What are the 4 ways you can fuel? Answer - Gravity
Pressure
Ariel
Hot
What are the 5 fuel contaminants? Answer - - Micro biological organisms
- Emulsion
- Sediments
- Miscellaneous
2026 UPDATE | WITH COMPLETE SOLUTION
What is the publication utilized to perform a turnaround inspection? Answer -
A1-V22-MRC-100
How long is a TA good for? Answer - 24 hours
Aside from time what can invalidate a turnaround inspection? Answer - TA
expires once aircraft is weight off wheels or maintenance other than servicing
is completed
What is the publication utilized for a daily inspection? Answer - A1-V22-MRC-
200
How long is a daily good for? Answer - 72 hours
What is the approximate time that is takes to complete a daily inspection
Answer - 3.5 hours
What method can you use to expedite a daily Answer - Adding more PC
How are corrosion inspection requirements identified in the daily cards?
Answer - There will be a "C" in the CRN column next to the step that have
corrosion inspection requirements
,Who are the three signers on the "A" sheet? Answer - PC, Safe for flight, and
Pilot
What is the SSS for the fuel sample kit pre-operational inspection? Answer -
SSS: 15AH
How long are fuel samples good for? Answer - 24 hours
What are the primary responsibilities of a plane captain outlined in the NAMP?
Answer - - Maintain currency and practical proficiency in all areas covered in
the PC training syllabus
- Closely supervise the training of assigned plane captain trainees.
What is ERAC? IRAC? Answer - Electronic rapid action change/ interim rapid
action change
What components are serviced with DOD-L-85734 Answer - T- TAGB
E- ELS
M- MWGB
P- PRGB
C- CFG
What is the minimum/ maximum PSI for pressure refueling the CMV-22?
Answer - 35-55 PSI
What is the hand signal for fire? Answer - Point at affected area and make a
large figure eight with other hand
, What happens when T-handles are armed? Answer - -Arms the appropriate
engines extinguishing fire bottles
-Shuts off fuel to the affected engine
-Removes back-up FADEC power
-Removes hyd pressure to EAPS blowers
-Closes fire doors
What do you have to do prior to and during pressure fueling and refueling?
why? Answer - Depress climb/dive valve poppet on the LFS, RFS, and RAS to
drain any trapped fuel in sponson vent system
Can you defuel on APU? Answer - No
What do you use to defuel? Answer - External power source
What is the PRGB and TAGB oil pressure Answer - 60-95 psi
What are the 4 ways you can fuel? Answer - Gravity
Pressure
Ariel
Hot
What are the 5 fuel contaminants? Answer - - Micro biological organisms
- Emulsion
- Sediments
- Miscellaneous
