BIPC 620
Save
Practice questions for this set
Learn
Studied 7 terms
Nice work, you're crushing it
Continue studying in Learn
Terms in this set (131)
Certified IPC Trainter CIT and 2 Years
Certified IPC Specilist certifications
exipre after how many years
Master IPC Trainers MIT are CIT and CIS only
authorized to ceritfy
A CIT is authorized to ceritfy CIS
, If permitted by company policy, a 90 days
CIT may grant an extension of up to
how many days
What module is required as a pre Module 1
req. for IPC 620 CIS certification
CIS retesting may be taken only after 24 hours
a minimum of
What is the correct order of Design, PCB Fabrication, Assemly, Cleaning and
production status Coating
The tolerance for magnification aid is Plus or Minus 15 (Chapter 1) Page 1-7
The Manufacturer shall (_1_2_3) have a N1D2D3 - PAGE 1-8
documented calibration system
What is a Process Indicator A condition that identifies a characteristics that
does not affect the form fit or function of a
product- should be monitored
Conditions that are not specified as Acceptable - Page 1-4
defective or as a process indicator
are considered
Illumination at the surface of 1000 lm/m^2 or 93 foot candles
workstation should be minimum of
A condition that is close to perfect Target
defines what type of condition
Save
Practice questions for this set
Learn
Studied 7 terms
Nice work, you're crushing it
Continue studying in Learn
Terms in this set (131)
Certified IPC Trainter CIT and 2 Years
Certified IPC Specilist certifications
exipre after how many years
Master IPC Trainers MIT are CIT and CIS only
authorized to ceritfy
A CIT is authorized to ceritfy CIS
, If permitted by company policy, a 90 days
CIT may grant an extension of up to
how many days
What module is required as a pre Module 1
req. for IPC 620 CIS certification
CIS retesting may be taken only after 24 hours
a minimum of
What is the correct order of Design, PCB Fabrication, Assemly, Cleaning and
production status Coating
The tolerance for magnification aid is Plus or Minus 15 (Chapter 1) Page 1-7
The Manufacturer shall (_1_2_3) have a N1D2D3 - PAGE 1-8
documented calibration system
What is a Process Indicator A condition that identifies a characteristics that
does not affect the form fit or function of a
product- should be monitored
Conditions that are not specified as Acceptable - Page 1-4
defective or as a process indicator
are considered
Illumination at the surface of 1000 lm/m^2 or 93 foot candles
workstation should be minimum of
A condition that is close to perfect Target
defines what type of condition
