NACE CIP 1 CBT Exam – Practice Questions and Answers
(Updated 2025/2026 Edition)
Dew point is the temperature at which - answercondensation occurs.
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank
lining is being applied. After application of the 19 coat you notice small blisters in
some areas of the applied lining. Your FIRST preferred course of action is to: -
answerDocument the problem and advise the Contractor and Owner's
representative.
If a contractor is using a poorly maintained compressor to supply air for abrasive
blast cleaning and conventional airspray, the coating inspector should perform a
- answerblotter test for the presence of oil and water.
Upon arrival of coating materials, the inspector should - answerobserve and
document the amount of material and batch numbers.
Relative humidity is - answera measure of the amount of moisture in the air
compared to saturation level.
Galvanic corrosion occurs on which of the following substrates? - answerMetal
When applying Thermal Spray Coatings the specification is most likely
to reference: - answerSSPC-CS 23.00/AWS C2.23/NACE No. 12
What is the minimum recommended distance away from an edge that an inspector
should take a measurement with a dial type magnetic pull off Dry Film
Thickness(DFT) gauge? - answer2.5 cm (1 inch)
Polymerization is the process of? - answerMonomers joining together.
An exposed area of the substrate or previous coat of a conductive material, often
caused by poor application technique is called: - answerHoliday
(Updated 2025/2026 Edition)
Dew point is the temperature at which - answercondensation occurs.
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank
lining is being applied. After application of the 19 coat you notice small blisters in
some areas of the applied lining. Your FIRST preferred course of action is to: -
answerDocument the problem and advise the Contractor and Owner's
representative.
If a contractor is using a poorly maintained compressor to supply air for abrasive
blast cleaning and conventional airspray, the coating inspector should perform a
- answerblotter test for the presence of oil and water.
Upon arrival of coating materials, the inspector should - answerobserve and
document the amount of material and batch numbers.
Relative humidity is - answera measure of the amount of moisture in the air
compared to saturation level.
Galvanic corrosion occurs on which of the following substrates? - answerMetal
When applying Thermal Spray Coatings the specification is most likely
to reference: - answerSSPC-CS 23.00/AWS C2.23/NACE No. 12
What is the minimum recommended distance away from an edge that an inspector
should take a measurement with a dial type magnetic pull off Dry Film
Thickness(DFT) gauge? - answer2.5 cm (1 inch)
Polymerization is the process of? - answerMonomers joining together.
An exposed area of the substrate or previous coat of a conductive material, often
caused by poor application technique is called: - answerHoliday
