IMSA Signal Technician Level 1 End of
Chapter EXAM NEWEST 2026 WITH
COMPLETE QUESTIONS AND CORRECT
DETAILED ANSWERS (VERIFIED
ANSWERS) |ALREADY GRADED A+
What is the primary function of the IMSA? -CORRECTANSWER Safety education
IMSA stands for: -CORRECTANSWER International Municipal Signal Association
Which of the following is NOT an IMSA certification? -CORRECTANSWER Y: Traffic
Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? -CORRECTANSWER Overhead
and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? -CORRECTANSWER Circular red,
circular green
, PPE stands for: -CORRECTANSWER Personal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of
aerial lift equipment? -CORRECTANSWER Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? -
CORRECTANSWER Ensure advance warning devices have not been removed or
relocated
Which of the following is NOT a sentence type in the MUTCD? -CORRECTANSWER Y:
Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason
not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic
Control Signals: -CORRECTANSWER Three-section traffic signal with circular red,
circular yellow, and smaller circular yellow indications
Chapter EXAM NEWEST 2026 WITH
COMPLETE QUESTIONS AND CORRECT
DETAILED ANSWERS (VERIFIED
ANSWERS) |ALREADY GRADED A+
What is the primary function of the IMSA? -CORRECTANSWER Safety education
IMSA stands for: -CORRECTANSWER International Municipal Signal Association
Which of the following is NOT an IMSA certification? -CORRECTANSWER Y: Traffic
Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? -CORRECTANSWER Overhead
and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? -CORRECTANSWER Circular red,
circular green
, PPE stands for: -CORRECTANSWER Personal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of
aerial lift equipment? -CORRECTANSWER Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? -
CORRECTANSWER Ensure advance warning devices have not been removed or
relocated
Which of the following is NOT a sentence type in the MUTCD? -CORRECTANSWER Y:
Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason
not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic
Control Signals: -CORRECTANSWER Three-section traffic signal with circular red,
circular yellow, and smaller circular yellow indications
