Page | 1
NCCCO OVERHEAD CRANE
QUESTIONS WITH CORRECT
ANSWERS LATEST UPDATE 2026
Overhead cranes with more than one hoisting unit shall have?
A) Its own daily inspection.
B) Its rated load marked on it.
C) A wind-indicating device.
D) Automatic rail clamps. - correct answer-B) Its rated load
marked on it.
What is the purpose the "E" (Emergency) stop on an overhead
crane?
A) Removes power to hoists only.
B) Removes power to entire bridge.
C) Removes power to trolley only.
D) Removes power to entire crane. - correct answer-D) Removes
power to entire crane.
How often does O.S.H.A require a written wire rope inspection?
A) Once a shift.
, Page | 2
B) Once a week.
C) Once a month.
D) Once a quarter. - correct answer-C) Once a month.
Most loads should be rigged to within how many degrees of level?
A) Two.
B) Three.
C) Four.
D) Five. - correct answer-D) Five.
According to ASME B30.2, what is the safety factor for rigging?
A) 3 to 1
B) 4 to 1
C) 5 to 1
D) 6 to 1 - correct answer-C) 5 to 1
According to O.S.H.A frequent inspections shall be performed.
A) Monthly to annually.
B) Daily to monthly.
C) Hourly to daily.
, Page | 3
D) Daily to weekly. - correct answer-B) Daily to monthly.
According to ASME B30.2 a frequent inspection must be
performed by?
A) Competent person.
B) Designated person.
C) Qualified person.
D) Authorized person. - correct answer-B) Designated person.
According to ASME B30.2, the maximum twist of the hook can't
exceed?
A) 10*
B) 0*
C) 15*
D) 20* - correct answer-B) 0*
When inspecting electrical contacts, what are the signs they are
bad?
A) Pitted or burned.
B) Discolored.
C) Springs are taut.
, Page | 4
D) Makes sparks. - correct answer-A) Pitted or burned.
According to ASME B30.2, what type of fire extinguisher is
required for overhead cranes?
A) 5BS
B) 10BC
C) 5C
D) 10A - correct answer-B) 10BC
Before leaving an overhead crane unattended, attached loads
should be?
A) Raised to the upper limit point.
B) Raised just above the floor.
C) Lowered to the floor.
D) Unhooked from the crane. - correct answer-C) Lowered to the
floor.
Before using your hand to steady any load, you should?
A) Follow company policies.
B) Wear approved gloves.
C) Follow foreman's direction.
NCCCO OVERHEAD CRANE
QUESTIONS WITH CORRECT
ANSWERS LATEST UPDATE 2026
Overhead cranes with more than one hoisting unit shall have?
A) Its own daily inspection.
B) Its rated load marked on it.
C) A wind-indicating device.
D) Automatic rail clamps. - correct answer-B) Its rated load
marked on it.
What is the purpose the "E" (Emergency) stop on an overhead
crane?
A) Removes power to hoists only.
B) Removes power to entire bridge.
C) Removes power to trolley only.
D) Removes power to entire crane. - correct answer-D) Removes
power to entire crane.
How often does O.S.H.A require a written wire rope inspection?
A) Once a shift.
, Page | 2
B) Once a week.
C) Once a month.
D) Once a quarter. - correct answer-C) Once a month.
Most loads should be rigged to within how many degrees of level?
A) Two.
B) Three.
C) Four.
D) Five. - correct answer-D) Five.
According to ASME B30.2, what is the safety factor for rigging?
A) 3 to 1
B) 4 to 1
C) 5 to 1
D) 6 to 1 - correct answer-C) 5 to 1
According to O.S.H.A frequent inspections shall be performed.
A) Monthly to annually.
B) Daily to monthly.
C) Hourly to daily.
, Page | 3
D) Daily to weekly. - correct answer-B) Daily to monthly.
According to ASME B30.2 a frequent inspection must be
performed by?
A) Competent person.
B) Designated person.
C) Qualified person.
D) Authorized person. - correct answer-B) Designated person.
According to ASME B30.2, the maximum twist of the hook can't
exceed?
A) 10*
B) 0*
C) 15*
D) 20* - correct answer-B) 0*
When inspecting electrical contacts, what are the signs they are
bad?
A) Pitted or burned.
B) Discolored.
C) Springs are taut.
, Page | 4
D) Makes sparks. - correct answer-A) Pitted or burned.
According to ASME B30.2, what type of fire extinguisher is
required for overhead cranes?
A) 5BS
B) 10BC
C) 5C
D) 10A - correct answer-B) 10BC
Before leaving an overhead crane unattended, attached loads
should be?
A) Raised to the upper limit point.
B) Raised just above the floor.
C) Lowered to the floor.
D) Unhooked from the crane. - correct answer-C) Lowered to the
floor.
Before using your hand to steady any load, you should?
A) Follow company policies.
B) Wear approved gloves.
C) Follow foreman's direction.
