age 1 of 27
BOILERMAKER NCCER EXAM ACTUAL EXAM
OSHA .......Answer.........The organization that requires a person
to be trained to operate personal lifting equipment.
RTJ Gasket .......Answer.........A gasket found in high pressure
systems.
Internal manway hardware .......Answer.........Examples include all
except slide fastener.
Union .......Answer.........The fitting that makes it easy to
disassemble threaded pipe.
Torque wrench .......Answer.........A type of wrench that measures
how much a fastener is being tightened.
Gasket .......Answer.........Used to create a seal between two
stationary parts.
,age 2 of 27
Material compatibility .......Answer.........The first consideration
when making a gasket.
Drift pin .......Answer.........The best tool to use to lift the bundle to
line up with the shell side gasket.
Ring gaskets .......Answer.........May be affected by all of the
following except the number of bolts.
Hacksaw blade .......Answer.........The teeth should face away
from the handle.
Pressure of pipes .......Answer.........The pressure is the same for
both 1" and 10" pipes when both are 20" tall.
Threaded connection .......Answer.........If it stops on the 2nd
thread, stop because something is wrong.
, age 3 of 27
Permatex .......Answer.........The material used to seal off between
the floating tube sheet and test ring in a heat exchanger.
Gasket for duct .......Answer.........Usually required when ducts are
bolted together.
Tube sheet damage .......Answer.........Caused by all except the
partition plate being too short.
Relief valve .......Answer.........Should be removed when pressure
testing the vessel.
Baffle components .......Answer.........Tie rods are attached to the
baffle on an exchanger tube bundle.
Safety hazards .......Answer.........All except improper inspection
are associated with vessel confined space.
BOILERMAKER NCCER EXAM ACTUAL EXAM
OSHA .......Answer.........The organization that requires a person
to be trained to operate personal lifting equipment.
RTJ Gasket .......Answer.........A gasket found in high pressure
systems.
Internal manway hardware .......Answer.........Examples include all
except slide fastener.
Union .......Answer.........The fitting that makes it easy to
disassemble threaded pipe.
Torque wrench .......Answer.........A type of wrench that measures
how much a fastener is being tightened.
Gasket .......Answer.........Used to create a seal between two
stationary parts.
,age 2 of 27
Material compatibility .......Answer.........The first consideration
when making a gasket.
Drift pin .......Answer.........The best tool to use to lift the bundle to
line up with the shell side gasket.
Ring gaskets .......Answer.........May be affected by all of the
following except the number of bolts.
Hacksaw blade .......Answer.........The teeth should face away
from the handle.
Pressure of pipes .......Answer.........The pressure is the same for
both 1" and 10" pipes when both are 20" tall.
Threaded connection .......Answer.........If it stops on the 2nd
thread, stop because something is wrong.
, age 3 of 27
Permatex .......Answer.........The material used to seal off between
the floating tube sheet and test ring in a heat exchanger.
Gasket for duct .......Answer.........Usually required when ducts are
bolted together.
Tube sheet damage .......Answer.........Caused by all except the
partition plate being too short.
Relief valve .......Answer.........Should be removed when pressure
testing the vessel.
Baffle components .......Answer.........Tie rods are attached to the
baffle on an exchanger tube bundle.
Safety hazards .......Answer.........All except improper inspection
are associated with vessel confined space.
