Virginia hic Exam (2026) QUESTIONS AND ALL
CORRECT ANSWERS 100% SOLVED AND
GUARANTEED SUCCESS!!
Save
Practice questions for this set
Learn 1 /7 Study with Learn
Terms in this set (124)
The MOST specific information about Floor plan
the size and location of windows
would be found in a
What direction does heat flow? Hot to cold
What are batter boards stakes and ledger boards marking building lines
, What is the MAXIMUM distance 3 feet
between a ventilating opening in an
under-floor space and each corner
of the building?
What is NOT required in exterior Load-bearing headers
nonbearing walls?
A lengthwise grain separation Shake (c 326)
between or through the growth rings
of lumber is called a
The abbreviation "d" in "16d" means Penny
Notches may not be located in the Middle 1/3
____________ of a joist span
How should board and batten be 1 inch overlap 10d nails
installed?
What is the maximum allowable 1/6 the depth of the member
notch in ceiling joists
How MUST rafters be framed to each Gusset plate (R802.3)
other
What is used to prevent buckling at Squash blocks
points of high stress?
Prior to the installation of wood floor 4-5 days
how long for acclimation?
CORRECT ANSWERS 100% SOLVED AND
GUARANTEED SUCCESS!!
Save
Practice questions for this set
Learn 1 /7 Study with Learn
Terms in this set (124)
The MOST specific information about Floor plan
the size and location of windows
would be found in a
What direction does heat flow? Hot to cold
What are batter boards stakes and ledger boards marking building lines
, What is the MAXIMUM distance 3 feet
between a ventilating opening in an
under-floor space and each corner
of the building?
What is NOT required in exterior Load-bearing headers
nonbearing walls?
A lengthwise grain separation Shake (c 326)
between or through the growth rings
of lumber is called a
The abbreviation "d" in "16d" means Penny
Notches may not be located in the Middle 1/3
____________ of a joist span
How should board and batten be 1 inch overlap 10d nails
installed?
What is the maximum allowable 1/6 the depth of the member
notch in ceiling joists
How MUST rafters be framed to each Gusset plate (R802.3)
other
What is used to prevent buckling at Squash blocks
points of high stress?
Prior to the installation of wood floor 4-5 days
how long for acclimation?
