QUESTIONS WITH CORRECT ANSWERS FOR
2025 GRADED A+
◉using extension cords if fixed wiring is not available . Answer: Each of
the following practices is considered a way to protect against
electrocution EXCEPT _____.
◉Voltage . Answer: Which of the following is a measure of the electrical
force that seems to push the current along?
◉Remove the power cord from service . Answer: What action is
required if the ground prong is missing from the male end of a power
cord?
◉electrical current . Answer: Whenever two wires are at different
voltages, _____ will pass between them if they are connected.
◉Make sure the systems are deenergized . Answer: To prevent
electrocution, what should workers do before performing repair work on
electrical systems?
, ◉Current and duration . Answer: The severity of injury from electrical
shock depends on which two factors below?
◉10 amps . Answer: Cardiac arrest, severe burns, and death is probable
if a worker receives an electrical shock of _____.
◉over 600 volts . Answer: OSHA classifies any use of electrical service
_____ as high voltage.
◉10 . Answer: Electrical currents above _____ milliamperes may have a
paralyzing or "freezing" effects on muscles.
◉Wet skin . Answer: Which of the following will result in lower
resistance and greater risk of injury when shocked?
◉Test the circuit to verify that it is deenergized . Answer: What should
you do to verify an electrical circuit is deenergized prior to working on
it?
◉Arcing . Answer: Which of the following is a luminous electrical
discharge occurs when high voltages exist across a gap between
conductors and current travels through the air?
◉bleve forces . Answer: Each of the following is a primary hazard
associated with an arc blast EXCEPT _____.