1|Page
IMSA Signal Technician Level 1 End of Chapter Exam
Questions Actual Complete Real Verified Exam
Questions with 100% Correct Answers | Verified
Answers | Already Graded A+ | Newest Exam!!!
Which of the following are potential safety hazards? -
Answer-Overhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - Answer-
Circular red, circular green
PPE stands for: - Answer-Personal Protective Equipment
Which of the follow is an example of adequate fall
protection during the operation of aerial lift equipment? -
Answer-Full body harness
Safety belt
Rails of a platform lift
,2|Page
Work Zone Supervisor is responsible for which of the
following tasks? - Answer-Ensure advance warning
devices have not been removed or relocated
Which of the following is NOT a sentence type in the
MUTCD? - Answer-Y: Standards; requirements that have
to be followed
Y: Guidance; recommendations that are to be followed
unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards
and guidance
Which of the following is an example configuration of an
Emergency-Vehicle Traffic Control Signals: - Answer-
Three-section traffic signal with circular red, circular
yellow, and smaller circular yellow indications
The following phases are typically assigned to the major
street through movements: - Answer-2 and 6
What is the primary function of the IMSA? - Answer-Safety
education
,3|Page
IMSA stands for: - Answer-International Municipal Signal
Association
Which of the following is NOT an IMSA certification? -
Answer-Y: Traffic Signal Level II Design/Engineer
Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
The green interval is made up which three components? -
Answer-Minimum green, passage time, maximum green
What are the three types of recall features of a traffic
signal controller? - Answer-Minimum, maximum,
pedestrian (+soft)
In a coordination plan, what is the number of seconds
given to each phase at the intersection? - Answer-Split
(g,y,r)
, 4|Page
Which of the following traffic signal coordination method is
typically least expensive? - Answer-Time-based
coordination
Which of the following is a definition of cycle length: -
Answer-The elapsed time between the start of a specific
display until that display comes up again
Which of the following is a characteristic of sequential
phases: - Answer-They cannot occur at the same time
Which of the following is a definition for initial green time: -
Answer-Minimum time that the green indication must be
displayed
The only point in the cycle of a coordinated traffic signal
controller where the major-street phase is allowed to end
is called: - Answer-Yield point
Which of the following is NOT a common mode of
operation for timing plans in a signal system: - Answer-Y:
Time of day
N: Traffic related
IMSA Signal Technician Level 1 End of Chapter Exam
Questions Actual Complete Real Verified Exam
Questions with 100% Correct Answers | Verified
Answers | Already Graded A+ | Newest Exam!!!
Which of the following are potential safety hazards? -
Answer-Overhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - Answer-
Circular red, circular green
PPE stands for: - Answer-Personal Protective Equipment
Which of the follow is an example of adequate fall
protection during the operation of aerial lift equipment? -
Answer-Full body harness
Safety belt
Rails of a platform lift
,2|Page
Work Zone Supervisor is responsible for which of the
following tasks? - Answer-Ensure advance warning
devices have not been removed or relocated
Which of the following is NOT a sentence type in the
MUTCD? - Answer-Y: Standards; requirements that have
to be followed
Y: Guidance; recommendations that are to be followed
unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards
and guidance
Which of the following is an example configuration of an
Emergency-Vehicle Traffic Control Signals: - Answer-
Three-section traffic signal with circular red, circular
yellow, and smaller circular yellow indications
The following phases are typically assigned to the major
street through movements: - Answer-2 and 6
What is the primary function of the IMSA? - Answer-Safety
education
,3|Page
IMSA stands for: - Answer-International Municipal Signal
Association
Which of the following is NOT an IMSA certification? -
Answer-Y: Traffic Signal Level II Design/Engineer
Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
The green interval is made up which three components? -
Answer-Minimum green, passage time, maximum green
What are the three types of recall features of a traffic
signal controller? - Answer-Minimum, maximum,
pedestrian (+soft)
In a coordination plan, what is the number of seconds
given to each phase at the intersection? - Answer-Split
(g,y,r)
, 4|Page
Which of the following traffic signal coordination method is
typically least expensive? - Answer-Time-based
coordination
Which of the following is a definition of cycle length: -
Answer-The elapsed time between the start of a specific
display until that display comes up again
Which of the following is a characteristic of sequential
phases: - Answer-They cannot occur at the same time
Which of the following is a definition for initial green time: -
Answer-Minimum time that the green indication must be
displayed
The only point in the cycle of a coordinated traffic signal
controller where the major-street phase is allowed to end
is called: - Answer-Yield point
Which of the following is NOT a common mode of
operation for timing plans in a signal system: - Answer-Y:
Time of day
N: Traffic related
