NCCER 26206-20 CERTIFICATION PAPER
2026 QUESTIONS WITH SOLUTIONS
GRADED A+
>> A dynamometer is designed to _____.
Answer: read pulling force during a cable pull
>> A good place to find data for supporting cable in vertical conduit runs is from
_____.
Answer: manufacturers' catalogs
>> A typical hand-crank wire puller, using 30 pounds of force, can pull up to
_____.
Answer: 1,500 pounds
>> Conveyor sheaves and rollers are MOST likely to be used when pulling cable
in _____.
Answer: cable trays
>> If the estimated pulling force is 900 lbs, the pulling rope should be rated for
_____.
Answer: 3,600 lbs
>> In general, a cable pull into cable tray should occur in a continuous operation
and at a rate of _____.
Answer: 20 to 25 feet per minute
>> In general, the allowable tension on a basket grip should NOT exceed _____.
2026 QUESTIONS WITH SOLUTIONS
GRADED A+
>> A dynamometer is designed to _____.
Answer: read pulling force during a cable pull
>> A good place to find data for supporting cable in vertical conduit runs is from
_____.
Answer: manufacturers' catalogs
>> A typical hand-crank wire puller, using 30 pounds of force, can pull up to
_____.
Answer: 1,500 pounds
>> Conveyor sheaves and rollers are MOST likely to be used when pulling cable
in _____.
Answer: cable trays
>> If the estimated pulling force is 900 lbs, the pulling rope should be rated for
_____.
Answer: 3,600 lbs
>> In general, a cable pull into cable tray should occur in a continuous operation
and at a rate of _____.
Answer: 20 to 25 feet per minute
>> In general, the allowable tension on a basket grip should NOT exceed _____.
