SACA Certification Study Guide 2026 – Smart Automation Certification Alliance Exam Questions, Notes & Training Materials

The top surface

Press any key to continue
Don't know?
Continue



Terms (75)

Hide definitions



What is the pressure shown on this gauge?*


500 kPa


What type of wrench is shown?*


Ratchet




What amount of power is used in this circuit?*


96W


What type of geometric tolerance is shown in the feature control frame on this drawing?


Circularity


A company's Emergency Action Plan (EAP) should include ALL of the following except?


Machine operation procedures

, What action must be taken to correctly position a dial caliper?


Sweep and rock to the jaws


What type of hand tool has a cross-shaped head to engage and tighten a fastener?*


Phillips head screwdriver


Which of these activities is considered non-value added activity in a lean manufacturing
environment?*
0/4


Moving a product from one station to another


What is the tolerance of the width of this part?*


+/-0.1


What do SDS sheets do?*


Specify material hazards.


When a click-type torque wrench clicks at the set point, what do you do to apply the proper
torque?


Stop turning the wrench


What type of hole is identified by the arrow labeled A?*


Blind