NCCER/OSHA Scaffold part 2
1. The footing or anchorage for scaffolds must be capa- C. Tying or guying
ble of carrying the maximum intended load without:
A. Diagonal bracing
B. Cross bracing
C. Tying or guying
D. Settling or displacement
2. Erectors of a scaffold who exposed to potential falling B. Over head protection
object hazards shall be provided with:
A. Static erectors
B. Overhead protection
C. Mono goggles
D. Full faced shields
3. Osha requires a rest landing at intervals not exceed: A. 35 feet
A. 35 feet
B. 40 feet
C. 45 feet
D. 50 feet
4. The top handrail of a scaffold must be able to with- D. 200
stand how many pounds of pressure?
A. 125
B. 150
C. 175
D. 200
5. When Building a scaffold inside a "goggle area" B. Everyone inside the
area must wear goggles
A. The scaffold builder must wear goggles only in the
ground
B. Everyone inside the area must wear goggles
, NCCER/OSHA Scaffold part 2
C. Only the worker in the bottom must wear goggles
D. The scaffold builder must wear safety glasses
6. The ladder should be located on a mobile scaffold will A. tip over
not
A. Tip over
B. Roll away
C. Move about
D. Shake violently
7. When should ties be installed? A. During the erection
A. During the erection process process
B. Immediately after erection is completed
C. When required by a foreman
D. When the scaffold will remain more than one work
shift
8. What body produces the primary Code or regulations B. OSHA (Occupation-
guiding the scaffolding industry? al Safety and Healthy
A. ANSI (American National Standards Institute) Agency)
B. OSHA (Occupational safety and healthy agency)
C. SIA (Scaffold Industry Association)
D. SSFI (Scaffold, Shoring, and Forming Institute)
9. What should be used to erect scaffolding on uneven C. Leveling Jacks
ground?
A. Solid bricks
B. Putlogs
C. Leveling Jacks
D. adjustment tubes
10. OSAH specifically prohibits the use of? C. Lean to scaffolds
A. Two point suspension swinging scaffolds
, NCCER/OSHA Scaffold part 2
B. Outrigger scaffolds
C. Lean to scaffold
D. Full face shield
11. Boards or wooden pad placed on the soil to support B. Mudsills
scaffold legs are?
A. Leg mats
B. Mudsills
C. Mud maes
D. Levelers
12. The tube of a tube and clamp scaffold is normally what C. 1.9 Inches
size O.D.?
A. 1.2 inches
B. 1.4 inches
C. 1.9 inches
D. 3.9 inches
13. Scaffold decks that overlap a minimum of how many B. 12
inches, unless secured in some other way?
A. 8
B. 12
C. 18
D. 24
14. the bearer in a tube and clamp scaffold is always? C. Placed above the adja-
A. Placed below the adjacent runner cent runner.
B. Vértice or plumb
C. Placed above the adjacent runner
D. Kept close to the ground
15. What must a rolling scaffold have on each caster or B. Positive locking device
roller?
1. The footing or anchorage for scaffolds must be capa- C. Tying or guying
ble of carrying the maximum intended load without:
A. Diagonal bracing
B. Cross bracing
C. Tying or guying
D. Settling or displacement
2. Erectors of a scaffold who exposed to potential falling B. Over head protection
object hazards shall be provided with:
A. Static erectors
B. Overhead protection
C. Mono goggles
D. Full faced shields
3. Osha requires a rest landing at intervals not exceed: A. 35 feet
A. 35 feet
B. 40 feet
C. 45 feet
D. 50 feet
4. The top handrail of a scaffold must be able to with- D. 200
stand how many pounds of pressure?
A. 125
B. 150
C. 175
D. 200
5. When Building a scaffold inside a "goggle area" B. Everyone inside the
area must wear goggles
A. The scaffold builder must wear goggles only in the
ground
B. Everyone inside the area must wear goggles
, NCCER/OSHA Scaffold part 2
C. Only the worker in the bottom must wear goggles
D. The scaffold builder must wear safety glasses
6. The ladder should be located on a mobile scaffold will A. tip over
not
A. Tip over
B. Roll away
C. Move about
D. Shake violently
7. When should ties be installed? A. During the erection
A. During the erection process process
B. Immediately after erection is completed
C. When required by a foreman
D. When the scaffold will remain more than one work
shift
8. What body produces the primary Code or regulations B. OSHA (Occupation-
guiding the scaffolding industry? al Safety and Healthy
A. ANSI (American National Standards Institute) Agency)
B. OSHA (Occupational safety and healthy agency)
C. SIA (Scaffold Industry Association)
D. SSFI (Scaffold, Shoring, and Forming Institute)
9. What should be used to erect scaffolding on uneven C. Leveling Jacks
ground?
A. Solid bricks
B. Putlogs
C. Leveling Jacks
D. adjustment tubes
10. OSAH specifically prohibits the use of? C. Lean to scaffolds
A. Two point suspension swinging scaffolds
, NCCER/OSHA Scaffold part 2
B. Outrigger scaffolds
C. Lean to scaffold
D. Full face shield
11. Boards or wooden pad placed on the soil to support B. Mudsills
scaffold legs are?
A. Leg mats
B. Mudsills
C. Mud maes
D. Levelers
12. The tube of a tube and clamp scaffold is normally what C. 1.9 Inches
size O.D.?
A. 1.2 inches
B. 1.4 inches
C. 1.9 inches
D. 3.9 inches
13. Scaffold decks that overlap a minimum of how many B. 12
inches, unless secured in some other way?
A. 8
B. 12
C. 18
D. 24
14. the bearer in a tube and clamp scaffold is always? C. Placed above the adja-
A. Placed below the adjacent runner cent runner.
B. Vértice or plumb
C. Placed above the adjacent runner
D. Kept close to the ground
15. What must a rolling scaffold have on each caster or B. Positive locking device
roller?
