Page|1
GEORGIA PEST CONTROL TEST | ACTUAL EXAM QUESTIONS
AND VERIFIED SOLUTIONS | GRADED A+ | LATEST UPDATED
20267/2027 | 100% EXCELLENT SCORES.
Which of the following is not a requirement of the Employee Registration
Program?
A. High School Graduate
B. Take and pass a written exam
C. Ten hours of classroom training
D. 70 hours of supervised on the job training - ANSWER-A. High School Graduate
Which of the following pest control employees are not included in the Employee
Registration Program?
A. Salespersons
B. Inspectors
C. Certified Applicators
D. Pest Control Technicians - ANSWER-C. Certified Applicators
, Page|2
In order to maintain his / her registration , an employee must complete:
A. Four hours of training every two years per category
B. Eight hours of training every five years per category
C. Four hours of training every five years per category
D. Eight hours of training every two years per category - ANSWER-B. Eight hours
of training every five years per category.
The safe use and proper disposal of pesticides are requirements of:
a. Department of Transportation (DOT)
b. Occupational Safety and Health Act (OSHA)
c. Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA)
d. Endangered Species Act - ANSWER-C) Federal Insecticide, Fungicide, and
Rodenticide Act (FIFRA)
The reason for calibrating equipment is to:
a. Make sure the motor is running properly
b. Make sure the pesticide is properly agitated
C. Check the pesticide flow so it can be applied at the proper rate
, Page|3
D. Check for leaks at the hose - ANSWER-C. Check the pesticide flow so it can be
applied at the proper rate
Which of the following procedures is not necessary for the proper application of
pesticide?
a. Pest identification
b. Using the lowest priced pesticide
c. Inspection
d. Pesticide selection - ANSWER-b. Using the lowest priced pesticide
Equipment should be recalibrated:
a. Periodically to see if the flow rate has changed
b. Anytime nozzles are changed
c. Anytime tips are changed
d. Anytime there is a significant change in the length of the hose
e. All of the above - ANSWER-E. All of the above
, Page|4
Which of the following factors is most important when selecting a pesticide?
a. Possible odor problems
b. Possibility of stains
c. Equipment suitable to apply the pesticide
d. Intended use of pesticide permitted by the label
e. Type of formulation - ANSWER-d. Intended use of pesticide permitted by the
label
A pesticide spot application means that the maximum size of any continuously
treated area cannot exceed:
a. 1 square foot
b. 2 square feet
c. 4 square feet
d. 6 square feet
e. None of the above - ANSWER-b. 2 square feet
GEORGIA PEST CONTROL TEST | ACTUAL EXAM QUESTIONS
AND VERIFIED SOLUTIONS | GRADED A+ | LATEST UPDATED
20267/2027 | 100% EXCELLENT SCORES.
Which of the following is not a requirement of the Employee Registration
Program?
A. High School Graduate
B. Take and pass a written exam
C. Ten hours of classroom training
D. 70 hours of supervised on the job training - ANSWER-A. High School Graduate
Which of the following pest control employees are not included in the Employee
Registration Program?
A. Salespersons
B. Inspectors
C. Certified Applicators
D. Pest Control Technicians - ANSWER-C. Certified Applicators
, Page|2
In order to maintain his / her registration , an employee must complete:
A. Four hours of training every two years per category
B. Eight hours of training every five years per category
C. Four hours of training every five years per category
D. Eight hours of training every two years per category - ANSWER-B. Eight hours
of training every five years per category.
The safe use and proper disposal of pesticides are requirements of:
a. Department of Transportation (DOT)
b. Occupational Safety and Health Act (OSHA)
c. Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA)
d. Endangered Species Act - ANSWER-C) Federal Insecticide, Fungicide, and
Rodenticide Act (FIFRA)
The reason for calibrating equipment is to:
a. Make sure the motor is running properly
b. Make sure the pesticide is properly agitated
C. Check the pesticide flow so it can be applied at the proper rate
, Page|3
D. Check for leaks at the hose - ANSWER-C. Check the pesticide flow so it can be
applied at the proper rate
Which of the following procedures is not necessary for the proper application of
pesticide?
a. Pest identification
b. Using the lowest priced pesticide
c. Inspection
d. Pesticide selection - ANSWER-b. Using the lowest priced pesticide
Equipment should be recalibrated:
a. Periodically to see if the flow rate has changed
b. Anytime nozzles are changed
c. Anytime tips are changed
d. Anytime there is a significant change in the length of the hose
e. All of the above - ANSWER-E. All of the above
, Page|4
Which of the following factors is most important when selecting a pesticide?
a. Possible odor problems
b. Possibility of stains
c. Equipment suitable to apply the pesticide
d. Intended use of pesticide permitted by the label
e. Type of formulation - ANSWER-d. Intended use of pesticide permitted by the
label
A pesticide spot application means that the maximum size of any continuously
treated area cannot exceed:
a. 1 square foot
b. 2 square feet
c. 4 square feet
d. 6 square feet
e. None of the above - ANSWER-b. 2 square feet
