PRACTICE EXAM QUESTIONS WITH
CORRECT DETAILED ANSWERS |
ALREADY GRADED A+<RECENT
vERSION>
1) Monitoring traps - ANSWER Estimating the numbers of pests present before and
after a control program (often uses pheromones)
2) Building plans - ANSWER Locating areas in the building that are warm and
humid
3) Inspection reports - ANSWER Listing the structural deficiencies contributing to
the pest problem.
4) Inspection Diagram - ANSWER Providing an overview of the structure and
surrounding area
5) Flashlight - ANSWER Viewing pests in their hiding places.
6) Flushing Agent - ANSWER Determining if pests are present in areas physically
impossible see.
7) Spraying is always considered essential to an effective structural pest management
program. - ANSWER False
8) Backpack sprayer - ANSWER Has a 2- to 5-gallon tank capacity and is
pressurized by priming a piston pump.
,9) Power sprayer - ANSWER Uses a relatively large tank to spray building
perimeters and lawns
10) Hand-held sprayer - ANSWER Most likely sprayer to select for use indoors in
smaller areas; pest control in cracks and crevices; applying flushing agents.
11) Backpack sprayer - ANSWER Most likely sprayer to select for treating larger
indoor areas (warehouses, commercial food facilities); outside, it is used on lawns,
along fences, and around building perimeters.
12) Hand-held sprayer - ANSWER Produces two different flow patterns: pin- stream
and flat-fan.
13) Hand-held sprayer Which type of nozzle spray pattern delivers the largest amount of
spray per minute at 20 psi? - ANSWER Coarse fan, 50 degrees
14) What is the advantage of using a crack and crevice extension tube on a nozzle? -
ANSWER It allows crack and crevice application with little spilling or splashing.
15) High pressure must be maintained in hand-held sprayers to be effective. -
ANSWER False
16) New sprayers are well calibrated until they have been used one season. -
ANSWER False
17) A general effective pressure for fan spray applications is: - ANSWER 20 to 25 psi.
18) For crack and crevice treatments, an effective pressure is - ANSWER Less than 10
psi.
19) Which are proper procedures when filling a sprayer? - ANSWER Check to see that
all components are working at the beginning of the day.
,20) If a sprayer malfunctions - ANSWER Release pressure and do not use again untill
repaired.
21) Equipment safety is best maintained by: - ANSWER Routine rinsing. Routine hose
inspection. Scheduled cleaning
22) What effect will increasing the pressure of a held sprayer have on flow rate? -
ANSWER Disproportional increase in flow rate
23) What effect will increasing travel speed have on the pesticide application rate? -
ANSWER Decrease application rate
24) What is the purpose of the pre calibration check? - ANSWER Determine if
equipment is operating properly Determine if spray application is uniform
25) Travel speed is less critical to structural pest management because the spray mixture
is normally on a percentage basis and to the point of runoff. - ANSWER True
26) In order to calibrate a hand held sprayer you must know - ANSWER How much
spray mixture your sprayer applies per unit area how much area you can spray per
tank the rate of pesticide application as specified by the label the amount of pesticide
product to add to the tank
27) List the steps needed to calibrate a hand-held sprayer - ANSWER Measure a
minimum of 250 square feet fill the sprayer with water to a level that is easily
recognized. Spray the area add water back to the tank multiply the volume by the
proper conversion
28) Define pest in simple terms - ANSWER Any unwanted organism
29) Define a pest in simple terms - ANSWER An unwanted organism
30) Pest populations are part of an ecosystem. What following elements are included in an
ecosystem?
, A. Populations and a community
B. A community and biological and physical supports
C. Populations and biological and physical supports
D. Populations, a community, and biological and physical supports -
ANSWER D
31) In infested apartments, pest infestations are evenly distributed?
A. True
B. False - ANSWER B
32) In a simple sequence of methods, which of the following is the first method or activity
a pest control technician should do?
A. Pesticide Application
B. Habitat alteration
C. Inspection
D. Follow up - ANSWER C
33) Which of the following are not integrated pest management components, goals or
activities:
A. Monitoring
B. Pesticide Application
C. Preventative Spraying
D. Recordkeeping
E. Total Pest Elimination - ANSWER C and E
34) The pest management style of pest control, more than the other styles, emphasizes:
A. Safe Pesticide application
B. The reduction of pests to a tolerable number
C. Inspection
D. Client Communication - ANSWER B
35) New sprayers are well calibrated until they have been used one season
A. True
B. False - ANSWER B
36) Hand held sprayers can be calibrated if the following is known:
A. Pressure used
B. Amount of liquid used
C. Time elapsed per liquid used