CCIE DATA CENTER WRITTEN EXAM TEST BANK
WITH 500+ QUESTIONS AND VERIFIED CORRECT
ANSWERS 2026-27 LATEST VERSION
QUESTION 1
In a configuration with redundant supervisors, how many IP addresses are required to
configure full remote access via management 0?
A. two IP addresses, one for each supervisor
B. three IP addresses, one virtual IP and one physical IP for each
supervisor
C. one IP address that is shared among supervisors
D. none--management 0 will use the IP address from the first SVI that is
created
Answer: C
QUESTION 2
VLAN configuration using DCNM can be completed by which two supported methods?
(Choose two.)
A. Copy and paste the VLAN, along with its VLAN ID, name, type, admin state, and admin
status, from
one device to another.
B. Create a single VLAN or a range of VLANs.
C. A VLAN is created only after choosing File > Deploy to apply changes.
D. After a VLAN is created, it requires the state to be enabled.
E. Modify the existing VLAN by choosing Interface > VLAN > VLAN Settings.
Answer: AB
QUESTION 3
Enabling jumbo frame support on a Cisco Nexus 5500 Switch can be done through
which method?
A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS
policy map
Answer: D
2
,QUESTION 4
Which two statements about authentication settings for DCNM-LAN are true? (Choose two.)
A. If none of the authentication servers that are configured for the current authentication
mode responds
to an authentication request, the DCNM-LAN server falls back to local authentication.
B. DCNM-LAN only supports TACACS+.
C. Each DCNM-LAN server will have the same device credentials.
D. Administering DCNM-LAN authentication settings requires an authentication license.
E. DCNM-LAN server users are local to the DCNM-LAN server.
Answer: AE
QUESTION 5
3
,DCNM is capable of monitoring the network performance of a SAN. What are the three primary
areas of this operation?
A. analyze traffic, device management, and network
monitoring
B. DCNM-SAN, DCNM-LAN, and device manager
C. definition of flows, information collection, and data
presentation
D. SNMP poll data, MIB analysis, and report generation
Answer: C
QUESTION 6
What is required for proper implementation of jumbo frame support on a Cisco Nexus
2000 Series Fabric Extender?
A. The interface configured as FEX fabric requires the MTU to be set to
jumbo.
B. The service policy must be applied to the system QoS.
C. The device defaults to jumbo frame support; no changes are required.
D. The switchport in the FEX interface must be set to MTU 9216.
Answer: B
QUESTION 7
DCNM device discovery is done by connecting to Cisco NX-OS devices and doing which
three of these? (Choose three.)
A. collecting the running configuration
B. raising the logging level to meet the minimum requirement
C. discovering all devices by default
D. discovering devices using multiple user accounts as long as they are administrator-level
accounts
E. using LLDP to discover network adaptors
Answer: ABE
QUESTION 8
What does the mac packet-classify command do when applied to an interface configuration?
A. It enables MAC ACLs to be applied to only IP packets that enter the
interface.
B. It enables MAC ACLs to be applied to only non-IP packets that enter the
interface.
C. It enables MAC ACLs to be applied to all packets that enter the interface.
D. It enables MAC ACLs to be used for QoS settings.
4
, Answer: C
QUESTION 9
In a virtual port channel (vPC) configuration, VRRP exhibits which characteristic?
A. VRRP does not work with vPC due to industry standard
requirements
B. VRRP works with vPC in traditional active/standby modes
C. VRRP works with vPC in an active/active mode
5
WITH 500+ QUESTIONS AND VERIFIED CORRECT
ANSWERS 2026-27 LATEST VERSION
QUESTION 1
In a configuration with redundant supervisors, how many IP addresses are required to
configure full remote access via management 0?
A. two IP addresses, one for each supervisor
B. three IP addresses, one virtual IP and one physical IP for each
supervisor
C. one IP address that is shared among supervisors
D. none--management 0 will use the IP address from the first SVI that is
created
Answer: C
QUESTION 2
VLAN configuration using DCNM can be completed by which two supported methods?
(Choose two.)
A. Copy and paste the VLAN, along with its VLAN ID, name, type, admin state, and admin
status, from
one device to another.
B. Create a single VLAN or a range of VLANs.
C. A VLAN is created only after choosing File > Deploy to apply changes.
D. After a VLAN is created, it requires the state to be enabled.
E. Modify the existing VLAN by choosing Interface > VLAN > VLAN Settings.
Answer: AB
QUESTION 3
Enabling jumbo frame support on a Cisco Nexus 5500 Switch can be done through
which method?
A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS
policy map
Answer: D
2
,QUESTION 4
Which two statements about authentication settings for DCNM-LAN are true? (Choose two.)
A. If none of the authentication servers that are configured for the current authentication
mode responds
to an authentication request, the DCNM-LAN server falls back to local authentication.
B. DCNM-LAN only supports TACACS+.
C. Each DCNM-LAN server will have the same device credentials.
D. Administering DCNM-LAN authentication settings requires an authentication license.
E. DCNM-LAN server users are local to the DCNM-LAN server.
Answer: AE
QUESTION 5
3
,DCNM is capable of monitoring the network performance of a SAN. What are the three primary
areas of this operation?
A. analyze traffic, device management, and network
monitoring
B. DCNM-SAN, DCNM-LAN, and device manager
C. definition of flows, information collection, and data
presentation
D. SNMP poll data, MIB analysis, and report generation
Answer: C
QUESTION 6
What is required for proper implementation of jumbo frame support on a Cisco Nexus
2000 Series Fabric Extender?
A. The interface configured as FEX fabric requires the MTU to be set to
jumbo.
B. The service policy must be applied to the system QoS.
C. The device defaults to jumbo frame support; no changes are required.
D. The switchport in the FEX interface must be set to MTU 9216.
Answer: B
QUESTION 7
DCNM device discovery is done by connecting to Cisco NX-OS devices and doing which
three of these? (Choose three.)
A. collecting the running configuration
B. raising the logging level to meet the minimum requirement
C. discovering all devices by default
D. discovering devices using multiple user accounts as long as they are administrator-level
accounts
E. using LLDP to discover network adaptors
Answer: ABE
QUESTION 8
What does the mac packet-classify command do when applied to an interface configuration?
A. It enables MAC ACLs to be applied to only IP packets that enter the
interface.
B. It enables MAC ACLs to be applied to only non-IP packets that enter the
interface.
C. It enables MAC ACLs to be applied to all packets that enter the interface.
D. It enables MAC ACLs to be used for QoS settings.
4
, Answer: C
QUESTION 9
In a virtual port channel (vPC) configuration, VRRP exhibits which characteristic?
A. VRRP does not work with vPC due to industry standard
requirements
B. VRRP works with vPC in traditional active/standby modes
C. VRRP works with vPC in an active/active mode
5
