and Revised Answers –2026-2027
A standpipe is 84 inches in diameter and 20 feet high. How many gallons are in
the standpipe when the water is 16 feet deep?
ANSWERS: 4,603
Check valves are used to
ANSWERS: permit flow in only one driection
Standard pumper connection fire hydranta should not be installed on
water mains smaller then inches in diameter.
ANSWERS: 6
Beards or long sideburns prohibit an operator from safely
ANSWERS: wearing the face mask of a self contained breathing apparatus.
The water table is defined as the
ANSWERS: upper surface of the groundwater.
The shaft speed of an electric motor is most commonly expressed in units of
ANSWERS: revolutions per minute
, A coupon test installation in a distribution system is used to
ANSWERS: determine the rate scaling or corrosion.
Disease causing bacteria are know as
ANSWERS: pathogenic
Normally, surface water and groundwater have a PH range of
ANSWERS: 6.8 to 8.5
Which is the best definition of turbidity in water?
ANSWERS: anything in water that scatters light
A competent person must inspect excavations and adjacent areas for hazards
ANSWERS: daily, prior to the start of work, and as needed throughout the shift.
The component of a centrifugal pump sometimes installed on the end of a
suction pipe to hold the priming is known as a
ANSWERS: foot valve
The principal purpose of an altitude valve on an elevated tank is to
ANSWERS: control maximum filling level in distribution storage.