OVERHEAD CRANE NCCCO EXAM SET
Q&A
1. What is the Safety Factor for Rigging?
A. 3 to 1
B. 4 to 1
C. 5 to 1
D. 6 to 1 - ANSWER -C
2. According to ASME a Frequent Inspection must be performed by a
A. Competent Person
B. Designated Person
C. Qualified Person
D. Authorized Person - ANSWER -B
3. According to ASME the amount of Twist of a Hook can not exceed
A. 0 degrees
B. 5 degrees
C. 10 degrees
D. 15 degrees - ANSWER -A
4. On Overhead Cranes with more than one hoist unit, each hoist shall have A. It's own
inspection log
B. It's Rated Load marked on it
C. A Wind Indicating Device
D. Automatic Rail Clamps - ANSWER -B
5. What is the purpose of the "E" (Emergency) stop?
A. Disables power to the Hoist
B. Disables power to the Bridge
C. Disables power to the Trolley
D. Disables power to all Crane functions - ANSWER -D
6. How often does OSHA require a Written Wire Rope Inspection?
A. Once a Shift
B. Once a week
C. Once a Month
D. Once a Quarter - ANSWER -C
7. What should the operator do when a Loss of Power occurs?
A. Attempt to Locate the Problem
B. Lower the Load to the Floor
C. Put the Controllers in the Off Position
D. Wait for the Power to be Restored - ANSWER -C
, 8. When Inspecting Electrical Contacts, what signs would be cause for concern?
A. Pitted or Burned
B. Springs are taut
C. Lagging and Wire Rope
D. Has Proper Warning Labels - ANSWER -A
9. According to ASME B30.2 What type of Fire Extinguisher is required for Overhead
Cranes?
A. 5BC
B. 10BC
C 5C
D. 10A - ANSWER -B
10. Before Leaving an Overhead Crane unattended, Suspended Loads should be
A. Raised to the Upper Limit
B. Raised Just Above the Floor
C. Lowered to the Floor
D. Left Hooked to the Crane - ANSWER -C
11. Before using your hand to steady any Suspended Load, you should
A. Follow Company Policy
B. Wear Approved Gloves
C. Wear an Approved Hardhat
D. Do What the Other People in the Crew are Doing - ANSWER -A
12. According to OSHA, the Rated Capacity of all Overhead Cranes Shall be
A. Filed in the Supervisor's Office
B. Clearly Marked on the Side of the Crane
C. Clearly Marked on Shipping Papers
D. Kept in the Owner's Office - ANSWER -B
13. When Attaching Spreaders to a Load, it is Important to Know That
A. The Higher the Spreader Angle, The Greater the Tension
B. The Lower The Spreader Angle, The Lesser The Tension
C. The Lower The Spreader Angle, The Greater The Tension
D. The Tension is Always the Same - ANSWER -C
14. Which is Correct in Order of Hitch Strength?
A. Vertical,Basket,Choker
B. Basket,Vertical,Choker
C. Basket,Choker,Vertical
D. Choker,Basket,Vertical - ANSWER -B
15. According to ASME, a Hook Throat Opening Must Not Exceed
A. 0% of the Original Size
Q&A
1. What is the Safety Factor for Rigging?
A. 3 to 1
B. 4 to 1
C. 5 to 1
D. 6 to 1 - ANSWER -C
2. According to ASME a Frequent Inspection must be performed by a
A. Competent Person
B. Designated Person
C. Qualified Person
D. Authorized Person - ANSWER -B
3. According to ASME the amount of Twist of a Hook can not exceed
A. 0 degrees
B. 5 degrees
C. 10 degrees
D. 15 degrees - ANSWER -A
4. On Overhead Cranes with more than one hoist unit, each hoist shall have A. It's own
inspection log
B. It's Rated Load marked on it
C. A Wind Indicating Device
D. Automatic Rail Clamps - ANSWER -B
5. What is the purpose of the "E" (Emergency) stop?
A. Disables power to the Hoist
B. Disables power to the Bridge
C. Disables power to the Trolley
D. Disables power to all Crane functions - ANSWER -D
6. How often does OSHA require a Written Wire Rope Inspection?
A. Once a Shift
B. Once a week
C. Once a Month
D. Once a Quarter - ANSWER -C
7. What should the operator do when a Loss of Power occurs?
A. Attempt to Locate the Problem
B. Lower the Load to the Floor
C. Put the Controllers in the Off Position
D. Wait for the Power to be Restored - ANSWER -C
, 8. When Inspecting Electrical Contacts, what signs would be cause for concern?
A. Pitted or Burned
B. Springs are taut
C. Lagging and Wire Rope
D. Has Proper Warning Labels - ANSWER -A
9. According to ASME B30.2 What type of Fire Extinguisher is required for Overhead
Cranes?
A. 5BC
B. 10BC
C 5C
D. 10A - ANSWER -B
10. Before Leaving an Overhead Crane unattended, Suspended Loads should be
A. Raised to the Upper Limit
B. Raised Just Above the Floor
C. Lowered to the Floor
D. Left Hooked to the Crane - ANSWER -C
11. Before using your hand to steady any Suspended Load, you should
A. Follow Company Policy
B. Wear Approved Gloves
C. Wear an Approved Hardhat
D. Do What the Other People in the Crew are Doing - ANSWER -A
12. According to OSHA, the Rated Capacity of all Overhead Cranes Shall be
A. Filed in the Supervisor's Office
B. Clearly Marked on the Side of the Crane
C. Clearly Marked on Shipping Papers
D. Kept in the Owner's Office - ANSWER -B
13. When Attaching Spreaders to a Load, it is Important to Know That
A. The Higher the Spreader Angle, The Greater the Tension
B. The Lower The Spreader Angle, The Lesser The Tension
C. The Lower The Spreader Angle, The Greater The Tension
D. The Tension is Always the Same - ANSWER -C
14. Which is Correct in Order of Hitch Strength?
A. Vertical,Basket,Choker
B. Basket,Vertical,Choker
C. Basket,Choker,Vertical
D. Choker,Basket,Vertical - ANSWER -B
15. According to ASME, a Hook Throat Opening Must Not Exceed
A. 0% of the Original Size
