Science Engineering Electrical Engineering
NICET 1 - Practice Fire Alarm Systems Level I
Edit Save
Students also studied
NICET Fire Alarm Level 1 Nicet Level 1 Fire Alarm Inspection ... NICET LEVEL 1 nicet le
107 terms 35 terms 86 terms 13 terms
jesus_cortez79 Preview snookiesfoot Preview benrufly Preview pbe
Practice questions for this set
Learn 1 /3 Study using Learn
What should be done with the originals of the contract documents in order to complete
as-built drawings?
Choose an answer
Copy the original drawings and mark Compile all as-built field data and change
1 2
changes on the duplicates. the original drawings accordingly.
Store the original drawings without any Discard all field data and create new
3 4
changes. drawings from scratch.
Don't know?
According to NFPA 72, how often shall waterflow devices Annually
be tested? 1 multiple choice option
, A wall-mounted visible appliance is being installed in a 12 inches
protected premises that has a height of 6.75 feet. In this
application, what is the maximum distance from the
ceiling that the appliance may be mounted?
For a Class B circuit, where is the end-of-line resistor at the device physically farthest from the panel
located? 3 multiple choice options
Click on the Exhibit button.Which one of the symbols C
shown represents a heat detector?
On a peaked ceiling, projected beam-type smoke 3 feet
detectors must be installed within which maximum
distance from the peak?
Which one of the following is a parallel circuit? a single heat detector
3 multiple choice options
According to OSHA, which electrical cord is safe to use? one that is free of cuts
3 multiple choice options
In a conventional fire alarm system, which component high- or low-air pressure switch
serves as a contact device that is normally open? 3 multiple choice options
Cables installed under a corrugated metal roof deck 1 1/2 inches (1.50)
must be located at least which minimum distance from
the roof deck?
After the fire alarm system installation has been
completed, at what interval should system smoke
detectors undergo functional testing, after the alarm
contractor has performed the acceptance test of the fire
alarm system?
Fire alarm cable will run exposed inside a building riser. CMP
Which three types of cable are acceptable for this 3 multiple choice options
installation? (Choose three.)
Fasteners shall be driven into which material when
working with conduit?
Which tool is required for mounting conduit? wire nuts
3 multiple choice options
NICET 1 - Practice Fire Alarm Systems Level I
Edit Save
Students also studied
NICET Fire Alarm Level 1 Nicet Level 1 Fire Alarm Inspection ... NICET LEVEL 1 nicet le
107 terms 35 terms 86 terms 13 terms
jesus_cortez79 Preview snookiesfoot Preview benrufly Preview pbe
Practice questions for this set
Learn 1 /3 Study using Learn
What should be done with the originals of the contract documents in order to complete
as-built drawings?
Choose an answer
Copy the original drawings and mark Compile all as-built field data and change
1 2
changes on the duplicates. the original drawings accordingly.
Store the original drawings without any Discard all field data and create new
3 4
changes. drawings from scratch.
Don't know?
According to NFPA 72, how often shall waterflow devices Annually
be tested? 1 multiple choice option
, A wall-mounted visible appliance is being installed in a 12 inches
protected premises that has a height of 6.75 feet. In this
application, what is the maximum distance from the
ceiling that the appliance may be mounted?
For a Class B circuit, where is the end-of-line resistor at the device physically farthest from the panel
located? 3 multiple choice options
Click on the Exhibit button.Which one of the symbols C
shown represents a heat detector?
On a peaked ceiling, projected beam-type smoke 3 feet
detectors must be installed within which maximum
distance from the peak?
Which one of the following is a parallel circuit? a single heat detector
3 multiple choice options
According to OSHA, which electrical cord is safe to use? one that is free of cuts
3 multiple choice options
In a conventional fire alarm system, which component high- or low-air pressure switch
serves as a contact device that is normally open? 3 multiple choice options
Cables installed under a corrugated metal roof deck 1 1/2 inches (1.50)
must be located at least which minimum distance from
the roof deck?
After the fire alarm system installation has been
completed, at what interval should system smoke
detectors undergo functional testing, after the alarm
contractor has performed the acceptance test of the fire
alarm system?
Fire alarm cable will run exposed inside a building riser. CMP
Which three types of cable are acceptable for this 3 multiple choice options
installation? (Choose three.)
Fasteners shall be driven into which material when
working with conduit?
Which tool is required for mounting conduit? wire nuts
3 multiple choice options
