FIREFIGHTER 1 FINAL COMPLETE
EXAM TESTBANK WITH 500
QUESTIONS AND ALL CORRECT
ANSWERS VERIFIED AND GRADED
A+ FOR A GUARANTEED PASS
What is the first step a firefighter should preform before donning the SCBA
check the air supply of the SCBA unit
The purpose of a pass device is to
sound an alarm if the firefighter is motionless for a set period of time
Oxygen deficient atmospheres are those having less then what percent of
oxygen in the air
19.5%
At the beginning of the shift, the firefighter should make sure the SCBA is at
least what percent full?
85%
There are two methods that can be used to don SCBA that is stored in a case
over the head and coat method
,Manufacturers should provide users of PPE with what
Cleaning instructions
The purpose of the use of reflective trim on PPE is to
increase the visability of the wearer to others
Tempered plate glass should be broken only as a last resort. It is
recommended that it be shattered by striking:
at lowest corner with the pick end of a fire axe
In what type of occupancy will fire fighters usually find sliding doors?
Residential
Once overhead doors have been forced, they should be:
blocked open
A K-tool is correctly positioned when the blades bite into the
cylinder
,What tool can be safely carried by two firefighters, although it is designed to
be used by 2-4 firefighters
battering ram
What tool is considered to be a pulling tool
Pike-pole
"Irons" are formed by combining a:
Flathead ax and a halligan.
What is an example of a hand-powered hydraulic spreader tool
rabbet tool
What tool iw used to pull out a cylinder lock mounted in a wood or heavy
metal door
K-tool
The most important factor to consider in forcible entry is to
select the right tool to do the job
Before fire fighters enter a burning building to perform rescue work, they
must first consider:
their own safety
, The term for a roll call taken by a supervisor at an emergency incident is a:
Personnel Accountability Report
OSHA regulations require that when firefighters are inside a structure fire, at
least how many trained and equipped firefighters must be standing by
outside
2
When referring to ladders, the term tie rod is used to describe a metal rod
running from
one beam to the other
When a ladder is raised, it should be placed at an angle of approximately
what degree to ensure a safe climb
75 degrees
A nonadjustable ladder that consists of only one section is called
single/wall ladder
Ladders should extend five rungs above the roof edge to aid firefighters in
climbing onto and off the ladder and
so firefighters can find the ladder in heavy smoke conditions
EXAM TESTBANK WITH 500
QUESTIONS AND ALL CORRECT
ANSWERS VERIFIED AND GRADED
A+ FOR A GUARANTEED PASS
What is the first step a firefighter should preform before donning the SCBA
check the air supply of the SCBA unit
The purpose of a pass device is to
sound an alarm if the firefighter is motionless for a set period of time
Oxygen deficient atmospheres are those having less then what percent of
oxygen in the air
19.5%
At the beginning of the shift, the firefighter should make sure the SCBA is at
least what percent full?
85%
There are two methods that can be used to don SCBA that is stored in a case
over the head and coat method
,Manufacturers should provide users of PPE with what
Cleaning instructions
The purpose of the use of reflective trim on PPE is to
increase the visability of the wearer to others
Tempered plate glass should be broken only as a last resort. It is
recommended that it be shattered by striking:
at lowest corner with the pick end of a fire axe
In what type of occupancy will fire fighters usually find sliding doors?
Residential
Once overhead doors have been forced, they should be:
blocked open
A K-tool is correctly positioned when the blades bite into the
cylinder
,What tool can be safely carried by two firefighters, although it is designed to
be used by 2-4 firefighters
battering ram
What tool is considered to be a pulling tool
Pike-pole
"Irons" are formed by combining a:
Flathead ax and a halligan.
What is an example of a hand-powered hydraulic spreader tool
rabbet tool
What tool iw used to pull out a cylinder lock mounted in a wood or heavy
metal door
K-tool
The most important factor to consider in forcible entry is to
select the right tool to do the job
Before fire fighters enter a burning building to perform rescue work, they
must first consider:
their own safety
, The term for a roll call taken by a supervisor at an emergency incident is a:
Personnel Accountability Report
OSHA regulations require that when firefighters are inside a structure fire, at
least how many trained and equipped firefighters must be standing by
outside
2
When referring to ladders, the term tie rod is used to describe a metal rod
running from
one beam to the other
When a ladder is raised, it should be placed at an angle of approximately
what degree to ensure a safe climb
75 degrees
A nonadjustable ladder that consists of only one section is called
single/wall ladder
Ladders should extend five rungs above the roof edge to aid firefighters in
climbing onto and off the ladder and
so firefighters can find the ladder in heavy smoke conditions
