Nicet level 1 Study Guide questions
Study online at https://quizlet.com/_6a5m5j
1. When testing a water level supervisory switch serving rises or falls over 3 inches
a pressure tank a signal shall indicate if the water level
_____________from the required level
(NFPA 72, Table 14.4.3.2 17 (j) (4)
2. If combination audible/visible appliances are installed the visible appliance
the location of the installed appliance shall be deter-
mined by the requirements of _______.
(Nfpa 72 18.4.8.1)
3. What is the maximum number of 12 gauge THHN 26
wires that can be installed in 1" EMT?
(Nec Annex C tables)
4. Two resistors are connected in parallel. R1 = 300 150 ohms
Ohms, R2 = 300 Ohms. What is their equivalent resis-
tance?
5. A Room is 200' long and 150' wide and the 8' high 12
ceiling is smooth and flat. A spot type heat detector
has been selected that is listed for a 50' maximum
spacing between detectors. According to NFPA 72 how
many detectors will be needed to protect this room?
x =
6. According to NFPA 72 the minimum number of restor- Two detectors or more on
able fixed temperature spot type heat detectors that each initiating device cir-
must be tested during each annual test is? cuit
(NFPA 72 14.4.4.5.1)
, Nicet level 1 Study Guide questions
Study online at https://quizlet.com/_6a5m5j
7. According to NFPA 72 how many spot type heat detec- 6
tors are required for a space that is 80' long and 55
floor wide with a smooth 10' ceiling? the detector is
listed for a maximum space between detectors of 30'
8. What color code requirement for a spot type heat White (NFPA 72, Table
detector rated at 200Ÿ
F 17.6.2.1)
9. Unless otherwise recommended by the manufactur- 10 years from the day-of
ers published instructions single and multiple stations manufacture. (NFPA 72,
smoke alarms installed in one and 2 family dwellings 14.4.7.1)
shall be replaced every
10. Fire alarm cables are permitted to be strapped to con- False (NEC 760.143)
duit to support the cable
11. Where non power limited wiring is installed exposed 7' ft
it must be mechanically protected within_____of the
finished floor
12. Fire-Warning equipment to be installed in residen- ANSI S3.41
tial occupancies shall produce the audible emergency
evacuation signal described in
13. According to NFPA 72, visible notification appliance 80 & 96
for non-sleeping areas must be mounted between ___
and ___ inches above the finished floor
14. If system impairment occurs, the owner must be no- in writing & within 24
tified ___ within ___ hours
15. A 20 X 20' ft room with a 20'ft high ceiling requires at 30 candela
a minimum a ___ ceiling mounted strobe
, Nicet level 1 Study Guide questions
Study online at https://quizlet.com/_6a5m5j
16. According to NFPA 72, a 40 x 40'ft room or area with a 60
10'ft ceiling is best covered by a ___ cd visible notifica-
tion appliance, centered on one wall.
17. Conductors returning to the fire alarm control panel Class A
(FACP) from the last field device on the circuit might
indicate a _____ circuit
18. Secondary power supplies for an emergency 24 hrs & 15 mins
voice/alarm communication fire alarm system shall be
capable of operating for minimum of ___ of standby
followed by ___ of alarm.
19. The fire alarm system primary power branch circuit Red
disconnecting means must be ___ in color.
20. The secondary power supply for protected premises 10 seconds
shall automatically provide power within ___ seconds
when primary power fails.
21. Under which of the following conditions shall When the temperature is
spot-type smoke detectors NOT be installed? over 100*F
22. Who is responsible for maintaining Personal Protec- YOU, the employee
tive Equipment?
23. What does GFCI stand for ? Ground Fault Circuit Inter-
rupter
24. A fixed-temperature, non-restorable spot type heat 15 years after
detector shall be tested ____ from initial installation.
25. 20*F
Study online at https://quizlet.com/_6a5m5j
1. When testing a water level supervisory switch serving rises or falls over 3 inches
a pressure tank a signal shall indicate if the water level
_____________from the required level
(NFPA 72, Table 14.4.3.2 17 (j) (4)
2. If combination audible/visible appliances are installed the visible appliance
the location of the installed appliance shall be deter-
mined by the requirements of _______.
(Nfpa 72 18.4.8.1)
3. What is the maximum number of 12 gauge THHN 26
wires that can be installed in 1" EMT?
(Nec Annex C tables)
4. Two resistors are connected in parallel. R1 = 300 150 ohms
Ohms, R2 = 300 Ohms. What is their equivalent resis-
tance?
5. A Room is 200' long and 150' wide and the 8' high 12
ceiling is smooth and flat. A spot type heat detector
has been selected that is listed for a 50' maximum
spacing between detectors. According to NFPA 72 how
many detectors will be needed to protect this room?
x =
6. According to NFPA 72 the minimum number of restor- Two detectors or more on
able fixed temperature spot type heat detectors that each initiating device cir-
must be tested during each annual test is? cuit
(NFPA 72 14.4.4.5.1)
, Nicet level 1 Study Guide questions
Study online at https://quizlet.com/_6a5m5j
7. According to NFPA 72 how many spot type heat detec- 6
tors are required for a space that is 80' long and 55
floor wide with a smooth 10' ceiling? the detector is
listed for a maximum space between detectors of 30'
8. What color code requirement for a spot type heat White (NFPA 72, Table
detector rated at 200Ÿ
F 17.6.2.1)
9. Unless otherwise recommended by the manufactur- 10 years from the day-of
ers published instructions single and multiple stations manufacture. (NFPA 72,
smoke alarms installed in one and 2 family dwellings 14.4.7.1)
shall be replaced every
10. Fire alarm cables are permitted to be strapped to con- False (NEC 760.143)
duit to support the cable
11. Where non power limited wiring is installed exposed 7' ft
it must be mechanically protected within_____of the
finished floor
12. Fire-Warning equipment to be installed in residen- ANSI S3.41
tial occupancies shall produce the audible emergency
evacuation signal described in
13. According to NFPA 72, visible notification appliance 80 & 96
for non-sleeping areas must be mounted between ___
and ___ inches above the finished floor
14. If system impairment occurs, the owner must be no- in writing & within 24
tified ___ within ___ hours
15. A 20 X 20' ft room with a 20'ft high ceiling requires at 30 candela
a minimum a ___ ceiling mounted strobe
, Nicet level 1 Study Guide questions
Study online at https://quizlet.com/_6a5m5j
16. According to NFPA 72, a 40 x 40'ft room or area with a 60
10'ft ceiling is best covered by a ___ cd visible notifica-
tion appliance, centered on one wall.
17. Conductors returning to the fire alarm control panel Class A
(FACP) from the last field device on the circuit might
indicate a _____ circuit
18. Secondary power supplies for an emergency 24 hrs & 15 mins
voice/alarm communication fire alarm system shall be
capable of operating for minimum of ___ of standby
followed by ___ of alarm.
19. The fire alarm system primary power branch circuit Red
disconnecting means must be ___ in color.
20. The secondary power supply for protected premises 10 seconds
shall automatically provide power within ___ seconds
when primary power fails.
21. Under which of the following conditions shall When the temperature is
spot-type smoke detectors NOT be installed? over 100*F
22. Who is responsible for maintaining Personal Protec- YOU, the employee
tive Equipment?
23. What does GFCI stand for ? Ground Fault Circuit Inter-
rupter
24. A fixed-temperature, non-restorable spot type heat 15 years after
detector shall be tested ____ from initial installation.
25. 20*F
