CHST STUDY GUIDE 26/27 QUESTIONS AND VERIFIED
ANSWERS GUARANTEED PASS RATED A+
Under which of the following incident casual factors would
"inadequate/substandard work procedures" apply?
Substandard management or oversight practices
The construction health and safety technician can best identify
the potential workplace hazards via:
Performing a rigorous worksite analysis
What type of OSHA violation can result in a fine of up to
250,000 if an employee death occurs?
Willful Violation
When performing safety calculations, especially in regard to
potential falls, which of the following correctly depicts the
acceleration of gravity constant?
32.2 ft/sec2
Using the Pythagorean Theorem, if a CHST wanted to find the
length of "a" knowing that "b" = 12 ft and "c" = 13 ft, what would
be the correct value for "a"? (Note: drawing is not to scale)
,5 ft
Which of the following is typically included in a worksite
analysis that addresses potential instances of workplace
violence?
A worksite security evaluation
A safety intervention is defined as an action to modify how
work is conducted with the ultimate goal being to enhance
worker safety and health. Which of the following would NOT be
characterized as a prototypical "safety intervention"?
Lost-time trend evaluation
Per OSHA 29 CFR 1910.23, a "floor-hole" is dimensionally
defined as :
Between 1 inch and 12 inches
Per ANSI Standards (ANSI/ASSE A1264.2 - Slip resistance on
walking/working surfaces), a coefficient of friction close to "0"
is regarded as:
Extremely slippery
,ASTM D 120-09 requires that rubber-insulating gloves for use
in live electrical work exceeding ____ must be____.
50 volts/Type 1
Which of the following is NOT typically considered a potential
hazard for vehicles such as bulldozers, backhoes, and
forklifts?
Carbon monoxide overexposure
Which of the following is NOT an example of " point-of-
operation" guarding?
Fiscal Guards
At a construction worksite, which of the is NOT a system or
device that is typically employed for limiting falls?
Pitons and safety cables
Which fo the following products is often utilized in the
workplace for reducing hazards associated with standing for
long periods of time?
Anti Fatigue Mats
, Per OSH protocol, the use of fall-protection equipment must
be used when a construction worker is at least ___ feet above
the ground?
6 Feet.
Which of the following is NOT generally considered a control
for storing materials safely?
Storing pipes and bars in racks that face main aisles.
During a rigging inspection, if the threat opening of a hook has
increased in excess of ___ Percent of the original throat
opening, it should be replaced.
15
An emergency plan should always include procedures for
sheltering in place, which need(s) to acknowledge which of the
following?
How to evacuate an area or structure when a shelter in place
is executed.
What is the definition of an "on-scene coordinator"?
A person who is in charge of coordinating various agencies
and departments to ensure that all needs responded to during
and after an event.
ANSWERS GUARANTEED PASS RATED A+
Under which of the following incident casual factors would
"inadequate/substandard work procedures" apply?
Substandard management or oversight practices
The construction health and safety technician can best identify
the potential workplace hazards via:
Performing a rigorous worksite analysis
What type of OSHA violation can result in a fine of up to
250,000 if an employee death occurs?
Willful Violation
When performing safety calculations, especially in regard to
potential falls, which of the following correctly depicts the
acceleration of gravity constant?
32.2 ft/sec2
Using the Pythagorean Theorem, if a CHST wanted to find the
length of "a" knowing that "b" = 12 ft and "c" = 13 ft, what would
be the correct value for "a"? (Note: drawing is not to scale)
,5 ft
Which of the following is typically included in a worksite
analysis that addresses potential instances of workplace
violence?
A worksite security evaluation
A safety intervention is defined as an action to modify how
work is conducted with the ultimate goal being to enhance
worker safety and health. Which of the following would NOT be
characterized as a prototypical "safety intervention"?
Lost-time trend evaluation
Per OSHA 29 CFR 1910.23, a "floor-hole" is dimensionally
defined as :
Between 1 inch and 12 inches
Per ANSI Standards (ANSI/ASSE A1264.2 - Slip resistance on
walking/working surfaces), a coefficient of friction close to "0"
is regarded as:
Extremely slippery
,ASTM D 120-09 requires that rubber-insulating gloves for use
in live electrical work exceeding ____ must be____.
50 volts/Type 1
Which of the following is NOT typically considered a potential
hazard for vehicles such as bulldozers, backhoes, and
forklifts?
Carbon monoxide overexposure
Which of the following is NOT an example of " point-of-
operation" guarding?
Fiscal Guards
At a construction worksite, which of the is NOT a system or
device that is typically employed for limiting falls?
Pitons and safety cables
Which fo the following products is often utilized in the
workplace for reducing hazards associated with standing for
long periods of time?
Anti Fatigue Mats
, Per OSH protocol, the use of fall-protection equipment must
be used when a construction worker is at least ___ feet above
the ground?
6 Feet.
Which of the following is NOT generally considered a control
for storing materials safely?
Storing pipes and bars in racks that face main aisles.
During a rigging inspection, if the threat opening of a hook has
increased in excess of ___ Percent of the original throat
opening, it should be replaced.
15
An emergency plan should always include procedures for
sheltering in place, which need(s) to acknowledge which of the
following?
How to evacuate an area or structure when a shelter in place
is executed.
What is the definition of an "on-scene coordinator"?
A person who is in charge of coordinating various agencies
and departments to ensure that all needs responded to during
and after an event.
