IICL CONTAINER INSPECTOR
EXAMINATION SET 2026 SOLVED
QUESTIONS GRADED A+
● Which of the following containers allows for easier loading and
unloading of large bulky stock, such as bombs? Answer: Side-Opening
● Which container component is highlighted? Answer: Threshold Plate
● Which container component is highlighted? Answer: Top End Rail
● Which container component is highlighted? Answer: Forklift Pockets
● Which container component is highlighted? Answer: Gooseneck
tunnel
● What must be displayed on both ends, both sides, and the top of a
container? Answer: ISO Identification Markings
● When inspecting containers, what tool would you use to inspect a
container's alignment? Answer: Measuring Tape
, ● When inspecting containers, what tool is used to determine weld
serviceability and the severity of corrosion? Answer: Welder's Hammer
● When inspecting containers, what tool is used to move containers by
lifting them at the corner fittings? Answer: Container handler
● Where do you find the container inspection checklist for a mobile
facility? Answer: MIL-STD-3037, Appendix A
● Which statement is true? Answer: MIL-STD-3037 has separate
paragraphs that document IMDG and non-IMDG criteria.
● What is the maximum allowable depth of a door header dent? Refer to
MIL-STD-3037, Section 4 as required. Answer: ¾" for IMDG, 1-⅜" for
general cargo
● Select the appropriate defect classification for the following container
defect: Dent 3/16" deep on the road side panel.
Refer to MIL-STD-3037, Section 4 as required. Answer: Minor
● Refer to DA Form 2404 below. What is the appropriate entry for Item
#5 in this example? Answer: Unserviceable for IMDG and Non-IDMG
EXAMINATION SET 2026 SOLVED
QUESTIONS GRADED A+
● Which of the following containers allows for easier loading and
unloading of large bulky stock, such as bombs? Answer: Side-Opening
● Which container component is highlighted? Answer: Threshold Plate
● Which container component is highlighted? Answer: Top End Rail
● Which container component is highlighted? Answer: Forklift Pockets
● Which container component is highlighted? Answer: Gooseneck
tunnel
● What must be displayed on both ends, both sides, and the top of a
container? Answer: ISO Identification Markings
● When inspecting containers, what tool would you use to inspect a
container's alignment? Answer: Measuring Tape
, ● When inspecting containers, what tool is used to determine weld
serviceability and the severity of corrosion? Answer: Welder's Hammer
● When inspecting containers, what tool is used to move containers by
lifting them at the corner fittings? Answer: Container handler
● Where do you find the container inspection checklist for a mobile
facility? Answer: MIL-STD-3037, Appendix A
● Which statement is true? Answer: MIL-STD-3037 has separate
paragraphs that document IMDG and non-IMDG criteria.
● What is the maximum allowable depth of a door header dent? Refer to
MIL-STD-3037, Section 4 as required. Answer: ¾" for IMDG, 1-⅜" for
general cargo
● Select the appropriate defect classification for the following container
defect: Dent 3/16" deep on the road side panel.
Refer to MIL-STD-3037, Section 4 as required. Answer: Minor
● Refer to DA Form 2404 below. What is the appropriate entry for Item
#5 in this example? Answer: Unserviceable for IMDG and Non-IDMG
