Based Systems | All Questions and Correct
Answers | Graded A+ | Verified Answers |
Just Released
When placing a LOTO on a system, how many locks should be applied? ---------
CORRECT ANSWER-----------------As many locks as their are personnel working on
the system.
A ladder must be able to support ____ times the weight of the expected load ------
---CORRECT ANSWER-----------------3.3
It is acceptable to enter into a confined space without an attendant, but only if all
other precautions and PPE are taken. ---------CORRECT ANSWER-----------------False
A defective air pressure gauge on the supply air of a dry pipe system is considered
a _____ ---------CORRECT ANSWER-----------------Critical deficiency
When taking a sprinkler system out of service, the following are approved sources
of a temporary water supply
,-A hose from a fire hydrant to the FDC
-A portable tank and pump
-A standby fire department pumper ---------CORRECT ANSWER-----------------True
When using a ladder for electrical work, _______ ---------CORRECT ANSWER---------
--------The rails must be non-conductive.
When using an aerial lift, you must
-Tie off with a lanyard
-Wear a hard hat
-Have received appropriate training ---------CORRECT ANSWER-----------------True
When an employee may be exposed to hazardous chemicals, when must training
be given?
-When they might be exposed to said chemical
-When new chemicals have been added to the work place ---------CORRECT
ANSWER-----------------True
Toxic chemicals will be hazardous in a confined space when the ______ is
exceeded ---------CORRECT ANSWER-----------------PEL
, A hydropnuematic pump is used to check for air leaks on a dry pipe system ---------
CORRECT ANSWER-----------------False
When shutting down a system for impairment you must hang a tag at _______ ----
-----CORRECT ANSWER-----------------System control valve and the FDC
Prior to entering a confined space, oxygen must be tested to be between ______ -
--------CORRECT ANSWER-----------------the minimum and maximum levels
Before opening a fire pump controller and measuring voltage and amps you must
be trained in _____ ---------CORRECT ANSWER-----------------NFPA 70E, arc flash,
and the proper PPE
When testing a antifreeze solutions, what tools are recommended? ---------
CORRECT ANSWER-----------------Refractometer, or hyrdometer
The person who performs the LOTO on a piece of equipment to perform repairs
or maintenance is the _______ ---------CORRECT ANSWER-----------------authorized
person