International Rodeo |QUESTIONS AND ANSWERS
| INSTANT DOWNLOAD
Save
Terms in this set (412)
What does "CLF" stand for? Current Limiting fuse, (used to protect expensive
equipment, has a clearing time of less than ½ a
cycle).
When the heat from an arc melts the Fulgurite,
silica sand in a current limiting fuse,
the glass like substance produced is
known as _____?
How many feet should a splice be 50ft. (Splices should not be made in spans crossing
made from the suspension end point over RR, rivers, canal, or highways. Conductor
on a transmission line? sometimes laid on polyethylene sheets to keep
splicing process clean).
Hydraulic tools operate with a fluid 10,000 lbs/in2,
pressure of ______ lb/in2?
Splices should be made at least ______ 12 inches,
inches from the edge of the nearest
tie wire, armor rod, or deadend
clamp on a distribution conductor.
, When field testing the insulation 3 minutes,
properties of an insulated boom for
"Bare-Hand Methods", how long
should the boom remain in contact
with the energized conductor?
Strain carriers have two different 2,000, 10,000,
weight ratings, one for light loads at
_____ lbs. or heavy loads at ____lbs.
It is necessary to heat the filament of Tungsten, 6,120
an incandescent lamp to 5,000
degrees to produce full brilliance,
because of this ______ metal is used
because its melting point is ____
degrees.
Radiation is measured in ______? Millirems
A conductor should never be payed Non-rotating
out from a ______ reel.
The compression-to-ventilation ratio 30:2
for CPR is _______.
A co-worker collapses and is Have someone call 911 & bring the AED.
unresponsive. You should tap the
shoulder of the patient and ask "are
you OK?". What is the very next
action step you take?
| INSTANT DOWNLOAD
Save
Terms in this set (412)
What does "CLF" stand for? Current Limiting fuse, (used to protect expensive
equipment, has a clearing time of less than ½ a
cycle).
When the heat from an arc melts the Fulgurite,
silica sand in a current limiting fuse,
the glass like substance produced is
known as _____?
How many feet should a splice be 50ft. (Splices should not be made in spans crossing
made from the suspension end point over RR, rivers, canal, or highways. Conductor
on a transmission line? sometimes laid on polyethylene sheets to keep
splicing process clean).
Hydraulic tools operate with a fluid 10,000 lbs/in2,
pressure of ______ lb/in2?
Splices should be made at least ______ 12 inches,
inches from the edge of the nearest
tie wire, armor rod, or deadend
clamp on a distribution conductor.
, When field testing the insulation 3 minutes,
properties of an insulated boom for
"Bare-Hand Methods", how long
should the boom remain in contact
with the energized conductor?
Strain carriers have two different 2,000, 10,000,
weight ratings, one for light loads at
_____ lbs. or heavy loads at ____lbs.
It is necessary to heat the filament of Tungsten, 6,120
an incandescent lamp to 5,000
degrees to produce full brilliance,
because of this ______ metal is used
because its melting point is ____
degrees.
Radiation is measured in ______? Millirems
A conductor should never be payed Non-rotating
out from a ______ reel.
The compression-to-ventilation ratio 30:2
for CPR is _______.
A co-worker collapses and is Have someone call 911 & bring the AED.
unresponsive. You should tap the
shoulder of the patient and ask "are
you OK?". What is the very next
action step you take?
