ASE G1 Test Prep (General Automobile Maintenance) Complete
Questions And Correct Answers (Verified
Answers) Already Graded A+ || Guaranteed
Success!! Newest Exam | Just Released!! 2026 -
2027
With the vehicle parked on level ground
Engine oil level should be checked ....
Low-Drag caliper
A quick-take-up master cylinder is required when what type of caliper design
is used on a vehicle ?
Glow plug or injector
What part should be removed to test cylinder compression on a diesel engine?
Technician B only
Technician A says that maintenance-free batteries use a large amount of water.
Technician B says that maintenance-free batteries use materials that reduce the
amount of water used by the battery.
Which technician is correct?
,The Square-Cut O-ring
What part causes the disc brake caliper piston to retract when the brakes are
released ?
Embittered
Adding a chemical to make ethylene glycol bitter to the taste is called ?
ANSI (American National Standards Institute)
All safety glasses should meet standards set by ?
Throttle Position Sensor (TPS)
A potentiometer, a three-wire variable resistor, is used in which type of sensor?
Technician B only
Technician A says that galvanic activity is the result of a poor ground connection.
Technician B says that electrolysis can occur with a poor ground connection.
Which technician is correct?
At the outlet of the fuel rail
Where is the fuel-pressure regulator located on a vacuum-biased port fuel-
injection system?
Tendency of oil to resist flowing
Oil viscosity indicates what ?
,Technician A only
Technician A says that with self-adjusting clutch systems, the release bearing
constantly rotates.
Technician B says the ball bearing portion of the release bearing should be
lubricated with high temperature grease during routine maintenance.
Which technician is correct?
30 mph
Hydroplaning can occur at speeds as low as ?
Vibration
Battery hold-down clamps or brackets help reduce ___ , which can greatly reduce
the capacity and life of any battery.
Gear reduction
A starter can be constructed in a smaller size due to the use of _____ and
permanent magnets.
Both Technicians A and B
Two technician are discussing the need for history of the vehicle. Technician A
says that an accident could cause faults due to hidden damage.
Technician B says that some faults could be related to a previous repair.
Which technician is correct?
, Both Technicians A and B
Technician A says the gear reduction occurs when the drive gear turns faster than
the driven gear.
Technician B says that overdrive occurs when the driven gear turns faster than the
drive gear.
Which technician is correct?
Neither Technician A nor B
Technician A says that the cooling system should be tested for leaks using a
pressure- operated pressure pump.
Technician B says that the freezing and boiling point of the coolant can be
tested using a thermometer.
Which technician is correct?
Technician B only
Technician A says that a wye-wound stator produces more maximum output than
the same alternator equipped with a delta-wound stator.
Technician B says than an alternator equipped with a delta-wound stator
produces more maximum output than a wye-wound stator. Which technician
is correct?
Technician B only
Technician A says that adjustable wrenches should be used when torquing
fasteners.
Technician B says that adjustable wrenches can round the edges of fasteners.
Which technician is correct?
clear/amber
Polyglycol brake fluid is what color ?
Questions And Correct Answers (Verified
Answers) Already Graded A+ || Guaranteed
Success!! Newest Exam | Just Released!! 2026 -
2027
With the vehicle parked on level ground
Engine oil level should be checked ....
Low-Drag caliper
A quick-take-up master cylinder is required when what type of caliper design
is used on a vehicle ?
Glow plug or injector
What part should be removed to test cylinder compression on a diesel engine?
Technician B only
Technician A says that maintenance-free batteries use a large amount of water.
Technician B says that maintenance-free batteries use materials that reduce the
amount of water used by the battery.
Which technician is correct?
,The Square-Cut O-ring
What part causes the disc brake caliper piston to retract when the brakes are
released ?
Embittered
Adding a chemical to make ethylene glycol bitter to the taste is called ?
ANSI (American National Standards Institute)
All safety glasses should meet standards set by ?
Throttle Position Sensor (TPS)
A potentiometer, a three-wire variable resistor, is used in which type of sensor?
Technician B only
Technician A says that galvanic activity is the result of a poor ground connection.
Technician B says that electrolysis can occur with a poor ground connection.
Which technician is correct?
At the outlet of the fuel rail
Where is the fuel-pressure regulator located on a vacuum-biased port fuel-
injection system?
Tendency of oil to resist flowing
Oil viscosity indicates what ?
,Technician A only
Technician A says that with self-adjusting clutch systems, the release bearing
constantly rotates.
Technician B says the ball bearing portion of the release bearing should be
lubricated with high temperature grease during routine maintenance.
Which technician is correct?
30 mph
Hydroplaning can occur at speeds as low as ?
Vibration
Battery hold-down clamps or brackets help reduce ___ , which can greatly reduce
the capacity and life of any battery.
Gear reduction
A starter can be constructed in a smaller size due to the use of _____ and
permanent magnets.
Both Technicians A and B
Two technician are discussing the need for history of the vehicle. Technician A
says that an accident could cause faults due to hidden damage.
Technician B says that some faults could be related to a previous repair.
Which technician is correct?
, Both Technicians A and B
Technician A says the gear reduction occurs when the drive gear turns faster than
the driven gear.
Technician B says that overdrive occurs when the driven gear turns faster than the
drive gear.
Which technician is correct?
Neither Technician A nor B
Technician A says that the cooling system should be tested for leaks using a
pressure- operated pressure pump.
Technician B says that the freezing and boiling point of the coolant can be
tested using a thermometer.
Which technician is correct?
Technician B only
Technician A says that a wye-wound stator produces more maximum output than
the same alternator equipped with a delta-wound stator.
Technician B says than an alternator equipped with a delta-wound stator
produces more maximum output than a wye-wound stator. Which technician
is correct?
Technician B only
Technician A says that adjustable wrenches should be used when torquing
fasteners.
Technician B says that adjustable wrenches can round the edges of fasteners.
Which technician is correct?
clear/amber
Polyglycol brake fluid is what color ?
