Lawn and Ornamental Exam Questions and Verified
Answers, 100% Guarantee Pass
1. Treating trees or ornamental plants for termites, specifically Formosan ter-
mites (coptotermes formosonus) requires licensure with the Texas SPCS IN THE
TERMITE CONTROL CATEGORY
2. The Texas Department of Agriculture (TDA)
Answer: The primary agency
3. The Texas structural Pest Control Service SPCS)
Answer: An enity within TDA's pesticide program
4. Integrated pest management (IPM)
Answer: Is a comprehensive approch to pest management that uses cultural, physical, biological and
chemical methods in a cultural and enviromentally sound manner
5. Ornamental IPM PROGRAMS DIFFER
Answer:
6. Proper identification of a pest is the key to controlling pests
, Answer:
7. Natural factors that influence pest populations include
Answer: Population development and dynamics, natural barriers and enemies, avaliability of shelter and
food and water supplies. These natural factors may cause pest populations to increase or decrease without any
influence from humans
8. Host plant resistance
Answer: The ability of some plants to tolerate damage from certain pests or be unsuitable for pest
development
9. Biological control
Answer: Involves manipulating the nature enemies of pests (predators, parasires, or pathogens
10. Plants vary considerably in their requirements for growth as well as their
susceptibility to plant pests
Answer:
11. Do not use more pesticide than label directs. Applying more than label rate
increases the cost and the chances of contaminating groundwater
Answer:
12. When possible mix and load the pesticides at least 100 feet from the surface
water or direct links to the groundwater
,Answer:
13. Consider whether your application promotes any special risk a, such as soil
injections in areas that have a shallow aquifer
Answer:
14. Do not allow pesticide to back siphon into your water source
Answer:
15. Be careful when disposing of used pesticides and pesticide containers in-
cluding rinse water
Answer:
16. Consider weather forcasts
Answer:
17. The movement of pesticides through the air during or after application is
usually called
Answer: Drift
18. Most pesticides movement in water is across the treated surface, runoff, or
downward from the surface leaching
Answer:
, 19. Sensitive Areas
Answer: Schools, playgrounds, hospital Areas in or
near surfacevwater
Areas where groundwater is near thevsurface
Locations near food or feed crops or oramental gardens
Areas where domestic animals live
Sites where the elderly or pregnant women might come in contact with the chemicals
20. Pesticide residues are the traces of pesticide that remain in the environment
after application
Answer:
21. Many pesticide labels call for the addition of some type of ADJUVANT, a
product designed to improve the effectiveness of a pesticide
Answer:
22. Surfactant
Answer: Wetting agents (compounds designed to make pesticide solutions wetter
23. Stickers
Answer: Added to a spray solution to coat the plant and protect it from a plant pest
24. Failure to correctly identify a pest can lead to
Answers, 100% Guarantee Pass
1. Treating trees or ornamental plants for termites, specifically Formosan ter-
mites (coptotermes formosonus) requires licensure with the Texas SPCS IN THE
TERMITE CONTROL CATEGORY
2. The Texas Department of Agriculture (TDA)
Answer: The primary agency
3. The Texas structural Pest Control Service SPCS)
Answer: An enity within TDA's pesticide program
4. Integrated pest management (IPM)
Answer: Is a comprehensive approch to pest management that uses cultural, physical, biological and
chemical methods in a cultural and enviromentally sound manner
5. Ornamental IPM PROGRAMS DIFFER
Answer:
6. Proper identification of a pest is the key to controlling pests
, Answer:
7. Natural factors that influence pest populations include
Answer: Population development and dynamics, natural barriers and enemies, avaliability of shelter and
food and water supplies. These natural factors may cause pest populations to increase or decrease without any
influence from humans
8. Host plant resistance
Answer: The ability of some plants to tolerate damage from certain pests or be unsuitable for pest
development
9. Biological control
Answer: Involves manipulating the nature enemies of pests (predators, parasires, or pathogens
10. Plants vary considerably in their requirements for growth as well as their
susceptibility to plant pests
Answer:
11. Do not use more pesticide than label directs. Applying more than label rate
increases the cost and the chances of contaminating groundwater
Answer:
12. When possible mix and load the pesticides at least 100 feet from the surface
water or direct links to the groundwater
,Answer:
13. Consider whether your application promotes any special risk a, such as soil
injections in areas that have a shallow aquifer
Answer:
14. Do not allow pesticide to back siphon into your water source
Answer:
15. Be careful when disposing of used pesticides and pesticide containers in-
cluding rinse water
Answer:
16. Consider weather forcasts
Answer:
17. The movement of pesticides through the air during or after application is
usually called
Answer: Drift
18. Most pesticides movement in water is across the treated surface, runoff, or
downward from the surface leaching
Answer:
, 19. Sensitive Areas
Answer: Schools, playgrounds, hospital Areas in or
near surfacevwater
Areas where groundwater is near thevsurface
Locations near food or feed crops or oramental gardens
Areas where domestic animals live
Sites where the elderly or pregnant women might come in contact with the chemicals
20. Pesticide residues are the traces of pesticide that remain in the environment
after application
Answer:
21. Many pesticide labels call for the addition of some type of ADJUVANT, a
product designed to improve the effectiveness of a pesticide
Answer:
22. Surfactant
Answer: Wetting agents (compounds designed to make pesticide solutions wetter
23. Stickers
Answer: Added to a spray solution to coat the plant and protect it from a plant pest
24. Failure to correctly identify a pest can lead to
