ASE BRAKES Exam 1 – Questions With Perfect Solutions

ASE BRAKES Exam 1 – Questions With Perfect
Solutions

Save




Terms in this set (40)



A drum is chattering on the brake A
lathe. This could be the result of:
A. Failure to install the dampening
belt.
B. Cutting too slowly.
C. Dull cutting blades.
D. Cutting speed too fast.


A vehicle is equipped with a hydro- C
boost brake system has a hard pedal
with little braking action. Which of the
following could be the cause?
A. Low brake fluid
B. Air in the brake fluid
C. Low power steering fluid
D. An overtightened power steering
belt


Which of the following could cause D
excessive noise while braking?
A. Worn wheel cylinders
B. Worn caliper pistons
C. Seized caliper slides
D. Missing clips

, A vehicle equipped with a "hill C
holding" option has an ABS code.
Which tool would most likely be used
to check the wheel speed sensor?
A. AC volt meter
B. Ohm meter
C. Scan tool
D. Ammeter


The brake system has a soft, sinking C
pedal with the engine running. The
brake fluid level is at the correct
height. Which of the following could
be the cause?
A. A restricted vacuum hose
B. A leaking master cylinder
C. A bypassing master cylinder
D. A stuck open vacuum check valve


Technician A says a hydro-boost A
system can use the power steering
pump to operate the booster.
Technician B says a hydro-boost
system can use engine vacuum to
operate the booster. Who is correct?
A. A
B. B
C. Both A and B
D. Neither A nor B


A disc brake caliper is dragging. All of D
the following could be the cause
EXCEPT:
A. Binding pins.
B. Sticking piston.
C. Binding caliper.
D. Worn brake pads.