SOS Brake & Braking System – Questions With
Correct Answers
Save
Practice questions for this set
Learn 1 /7 Study using Learn
Neither A or B
Choose an answer
Technician A says it is normal for the amber "Anti-Lock Brake" lamp to light when the
1 system is activated during braking. Technician B says it is normal for the red "Anti-Lock
Brake" lamp to be on whenever the ignition is on and the engine is off. Who is right?
2 In a single anchor bendix drum type rear brake
During a road test, you find that when normal breaking pressure is applied the pedal
3
slowly goes to the floor. What is the likely cause of this problem?
4 Which of the following could be a symptom of over-torqued lug nuts?
Don't know?
Terms in this set (84)
, In a single anchor bendix drum type the secondary lining is longer than the primary
rear brake
Compared to the secondary shoe smaller and goes toward the front of the car
lining areas of drum brakes, the
primary shoe lining area is:
During a brake overhaul, you notice flush the system before the new parts are installed
that the brake fluid seems to be very
dirty and dark in color. What should
you do?
In order to bleed the system on a None of the above
vehicle equipped with power brakes:
Which of the following could be a A brake pedal pulsation during braking.
symptom of over-torqued lug nuts?
Which of the following describes the RR, LR, RF, LF
proper sequence to bleed brake lines
on most rear wheel drive vehicles:
In disc brake caliper assemblies, the In the caliper piston bore
"square cut seal" is usually located:
When performing a caliper overhaul, Compressed air
what would you use to remove the
pistons from the calipers?
Sliding caliper disc brake pads are Square cut piston seal
kept in adjustment by the
A cracked or torn vacuum diaphragm Hard pedal with very high effort required
in a power booster would likely cause:
Correct Answers
Save
Practice questions for this set
Learn 1 /7 Study using Learn
Neither A or B
Choose an answer
Technician A says it is normal for the amber "Anti-Lock Brake" lamp to light when the
1 system is activated during braking. Technician B says it is normal for the red "Anti-Lock
Brake" lamp to be on whenever the ignition is on and the engine is off. Who is right?
2 In a single anchor bendix drum type rear brake
During a road test, you find that when normal breaking pressure is applied the pedal
3
slowly goes to the floor. What is the likely cause of this problem?
4 Which of the following could be a symptom of over-torqued lug nuts?
Don't know?
Terms in this set (84)
, In a single anchor bendix drum type the secondary lining is longer than the primary
rear brake
Compared to the secondary shoe smaller and goes toward the front of the car
lining areas of drum brakes, the
primary shoe lining area is:
During a brake overhaul, you notice flush the system before the new parts are installed
that the brake fluid seems to be very
dirty and dark in color. What should
you do?
In order to bleed the system on a None of the above
vehicle equipped with power brakes:
Which of the following could be a A brake pedal pulsation during braking.
symptom of over-torqued lug nuts?
Which of the following describes the RR, LR, RF, LF
proper sequence to bleed brake lines
on most rear wheel drive vehicles:
In disc brake caliper assemblies, the In the caliper piston bore
"square cut seal" is usually located:
When performing a caliper overhaul, Compressed air
what would you use to remove the
pistons from the calipers?
Sliding caliper disc brake pads are Square cut piston seal
kept in adjustment by the
A cracked or torn vacuum diaphragm Hard pedal with very high effort required
in a power booster would likely cause:
