MECHANIC LICENSE TEST - UBSR & CRM :–
Questions With Step By Step Solutions
Save
Terms in this set (86)
SHOULD ANY OF THE FOLLOWING NO, NONE OF THOSE
FLUIDS BE USED TO TOP OFF A
BRAKE RESERVOIR: ETHYLENE
GLYCOL, POWER STEERING FLUID,
OR DEXRON 2?
WHAT IS THE PROPER WAY TO REPLACEMENT WITH DOUBLE-FLARED STEEL LINE
REPAIR A BRAKE LINE?
IF A DRIVE SHAFT IS REMOVED, MARK THE SHAFT SO IT CAN BE REINSTALLED
WHAT PRECAUTION SHOULD BE WITH ITS ORIGINAL RELATIONSHIP TO THE
TAKEN? MATING PARTS TO PRESERVE BALANCE
BEFORE DOING ELECTRICAL DISCONNECT THE BATTERY GROUND CABLE
REPAIRS, WHAT PRECAUTION
SHOULD BE TAKEN?
WHEN SPLICING ELECTRICAL ROSIN CORE
CONNECTIONS, WHAT TYPE OF
SOLDER SHOULD BE USED?
WHAT TOOL SHOULD BE USED TO A DIAL INDICATOR
CHECK LATERAL RUN OUT (BENT
CONDITION) ON A WHEEL OR A
DRIVE AXLE?
, WHAT IS THE PROPER WAY TO TORQUE THE ADJUSTING NUT TO 25 FTLBS TO SEAT
ADJUST TAPERED ROLLER WHEEL THE BEARING, BACK OFF THE PRELOAD, THEN
BEARINGS? FINGER-TIGHTEN THE ADJUSTING NUT WHILE
ROTATING THE WHEEL
AFTER REPLACING A POWER CYCLE THE SYSTEM BY TURNING THE STEERING
STEERING HOSE, WHAT SHOULD BE WHEEL LOCK-TO-LOCK SEVERAL TIMES
DONE TO REMOVE TRAPPED AIR IN
THE SYSTEM
WHAT IS THE PROPER PROCEDURE ALWAYS REPLACE A DAMAGED SAFETY DEVICE
WHEN WORKING ON AN ENERGY-
ABSORBING SAFETY DEVICE (I.E.
BUMPER SHOCK
ABSORBERS/INFLATABLE DASHES)?
WHAT RATIO SHOULD ANTI-FREEZE 50/50
AND WATER BE MIXED FOR
MAXIMUM FREEZE & HEAT
PROTECTION?
AUTOMATIC TRANSMISSION SPLICE THE LINES WITH BRASS COMPRESSION
COOLER LINES CAN BE BEST FITTINGS
REPAIRED BY WHAT METHOD?
WHICH OF THE FOLLOWING IS USED FUSIBLE LINK
TO PROTECT ELECTRICAL
COMPONENTS FROM OVERLOAD?
IF A FUEL LINE IS REPLACED THE FUEL WOULD BE LEAKING UNDER PRESSURE,
BETWEEN THE FUEL PUMP & THE WHICH IS LIKELY TO CAUSE A FIRE
CARBURETOR, WHY MUST YOU TAKE
CARE TO PREVENT LEAKS?
IF THE RADIATOR HAS BEEN PUSHED THE WATER PUMP SHAFT & BEARING
INTO A WATER-PUMP-MOUNTED
FAN, WHAT SHOULD BE EXAMINED
BEFORE THE REPAIR IS COMPLETED?
Questions With Step By Step Solutions
Save
Terms in this set (86)
SHOULD ANY OF THE FOLLOWING NO, NONE OF THOSE
FLUIDS BE USED TO TOP OFF A
BRAKE RESERVOIR: ETHYLENE
GLYCOL, POWER STEERING FLUID,
OR DEXRON 2?
WHAT IS THE PROPER WAY TO REPLACEMENT WITH DOUBLE-FLARED STEEL LINE
REPAIR A BRAKE LINE?
IF A DRIVE SHAFT IS REMOVED, MARK THE SHAFT SO IT CAN BE REINSTALLED
WHAT PRECAUTION SHOULD BE WITH ITS ORIGINAL RELATIONSHIP TO THE
TAKEN? MATING PARTS TO PRESERVE BALANCE
BEFORE DOING ELECTRICAL DISCONNECT THE BATTERY GROUND CABLE
REPAIRS, WHAT PRECAUTION
SHOULD BE TAKEN?
WHEN SPLICING ELECTRICAL ROSIN CORE
CONNECTIONS, WHAT TYPE OF
SOLDER SHOULD BE USED?
WHAT TOOL SHOULD BE USED TO A DIAL INDICATOR
CHECK LATERAL RUN OUT (BENT
CONDITION) ON A WHEEL OR A
DRIVE AXLE?
, WHAT IS THE PROPER WAY TO TORQUE THE ADJUSTING NUT TO 25 FTLBS TO SEAT
ADJUST TAPERED ROLLER WHEEL THE BEARING, BACK OFF THE PRELOAD, THEN
BEARINGS? FINGER-TIGHTEN THE ADJUSTING NUT WHILE
ROTATING THE WHEEL
AFTER REPLACING A POWER CYCLE THE SYSTEM BY TURNING THE STEERING
STEERING HOSE, WHAT SHOULD BE WHEEL LOCK-TO-LOCK SEVERAL TIMES
DONE TO REMOVE TRAPPED AIR IN
THE SYSTEM
WHAT IS THE PROPER PROCEDURE ALWAYS REPLACE A DAMAGED SAFETY DEVICE
WHEN WORKING ON AN ENERGY-
ABSORBING SAFETY DEVICE (I.E.
BUMPER SHOCK
ABSORBERS/INFLATABLE DASHES)?
WHAT RATIO SHOULD ANTI-FREEZE 50/50
AND WATER BE MIXED FOR
MAXIMUM FREEZE & HEAT
PROTECTION?
AUTOMATIC TRANSMISSION SPLICE THE LINES WITH BRASS COMPRESSION
COOLER LINES CAN BE BEST FITTINGS
REPAIRED BY WHAT METHOD?
WHICH OF THE FOLLOWING IS USED FUSIBLE LINK
TO PROTECT ELECTRICAL
COMPONENTS FROM OVERLOAD?
IF A FUEL LINE IS REPLACED THE FUEL WOULD BE LEAKING UNDER PRESSURE,
BETWEEN THE FUEL PUMP & THE WHICH IS LIKELY TO CAUSE A FIRE
CARBURETOR, WHY MUST YOU TAKE
CARE TO PREVENT LEAKS?
IF THE RADIATOR HAS BEEN PUSHED THE WATER PUMP SHAFT & BEARING
INTO A WATER-PUMP-MOUNTED
FAN, WHAT SHOULD BE EXAMINED
BEFORE THE REPAIR IS COMPLETED?
