Tennessee CCTV Qualifying Agent Licensing & Certification EXAM
Exam Coverage:
CCTV system design, installation and wiring, equipment configuration,
low-voltage regulations, troubleshooting, safety practices, and
Tennessee licensing laws.
The Tennessee CCTV Qualifying Agent Licensing & Certification exam
evaluates a candidate's ability to properly design, install, and maintain
surveillance systems. It focuses on camera types, recording systems,
network integration, and compliance with electrical and safety
standards such as the National Fire Protection Association and the
National Electrical Code, along with adherence to state regulatory
requirements.
,Control of egress shall comply with the requirements of the applicable
codes and standards based on:
NFPA 70
What measurement is used to test for conductivity of a circuit?
Continuity
Primary power supplies that include Class 2 or Class 3 plug in the
transformers utilizing receptacles need to be:
Mechanically secured
, GSM and CDMA are two types of:
Cellular networks
What safety features must be on power tools used in the work place?
Properly fitting guards and safety switches
When providing first aid to a victim of heat stroke, what should be
done first?
Take steps to lower the person's body temperature
Exam Coverage:
CCTV system design, installation and wiring, equipment configuration,
low-voltage regulations, troubleshooting, safety practices, and
Tennessee licensing laws.
The Tennessee CCTV Qualifying Agent Licensing & Certification exam
evaluates a candidate's ability to properly design, install, and maintain
surveillance systems. It focuses on camera types, recording systems,
network integration, and compliance with electrical and safety
standards such as the National Fire Protection Association and the
National Electrical Code, along with adherence to state regulatory
requirements.
,Control of egress shall comply with the requirements of the applicable
codes and standards based on:
NFPA 70
What measurement is used to test for conductivity of a circuit?
Continuity
Primary power supplies that include Class 2 or Class 3 plug in the
transformers utilizing receptacles need to be:
Mechanically secured
, GSM and CDMA are two types of:
Cellular networks
What safety features must be on power tools used in the work place?
Properly fitting guards and safety switches
When providing first aid to a victim of heat stroke, what should be
done first?
Take steps to lower the person's body temperature
