M777A2 HOWITZER QUESTIONS AND ANSWERS 2026 WITH COMPLETE SOLUTION.
OFC - (ANSWER)Optical Fire Control
What is referred to as the front? - (ANSWER)Muzzle End
Can you mix rechargeable and non-rechargeable batteries? - (ANSWER)No
What class of fire extinguishers is used to put out battery fires? - (ANSWER)D
What is DFCS and what does it provide? - (ANSWER)Digital Fire Contro Systeml; gun location, pointing,
navigation, digital communications
One turn of the elevation ranges for the m777a2? - (ANSWER)10 mils
What is the elevation ranges for m77a2 - (ANSWER)-43 mils to +1275 mils
What are the rates of fire for the m777a2? - (ANSWER)4 rounds/min every 2 mins
2 rounds/min determined by the TWD
What is the traversing range of the m777a2? - (ANSWER)400 left 400 right
What is the weight of the m777a2? - (ANSWER)w 9887
w/o 9277
Section drill must be conducted in ______, except for commands and report. - (ANSWER)Silence
When looking at the oil index pin, if the pin is not flush, what condition exists? - (ANSWER)Low oil
, M777A2 HOWITZER QUESTIONS AND ANSWERS 2026 WITH COMPLETE SOLUTION.
The scavenge isolator valve must be ____ when working around the breech. Failure to ______ the valve
could result in inadvertent breech motion. - (ANSWER)Close
Do not open ____ on prime mover when howitzer is attached, damage may occur to the muzzle brake
and lunnette assembly. - (ANSWER)Tail gate
The combined weight of the spade trail arm and blade is ____ and must be supported by a minimum of
two personnel. - (ANSWER)204lbs
Remain at least ___ feet from transmitting antenna of howitzer mounted radios. - (ANSWER)2
Suspension levers must be operated simultaneously. The howitzer cannot be lowered until the following
steps have been completed: - (ANSWER)•Handbrakes are applied, •Lunette is unhooked from prime
mover, •Cannon is supported by minimum of two personnel, •Stabilizers have been deployed
When laying the howitzer with the M2 Aiming Circle, the cross hairs must be +/- ____ mils before the
Gunner commands "READY, DROP" - (ANSWER)10
How deep must the spades be dug in when emplacing the howitzer? - (ANSWER)3 inched indirect, 6
inches direct
The loading tray can only be operated when the ____. - (ANSWER)breech is open
Emplaced distances away from weapon will vary due to type of terrain but must be between ____. The
M1A2 collimator should not be emplaced more than 4.4yds (4m) above or below the Pantel. -
(ANSWER)9-12m
What is the minimum amount of mils that must be visible on the M1A2 collimator when being layed on
the pantel? - (ANSWER)7 mils
When emplacing the aiming posts, what does a clenched fist mean? - (ANSWER)Stop
OFC - (ANSWER)Optical Fire Control
What is referred to as the front? - (ANSWER)Muzzle End
Can you mix rechargeable and non-rechargeable batteries? - (ANSWER)No
What class of fire extinguishers is used to put out battery fires? - (ANSWER)D
What is DFCS and what does it provide? - (ANSWER)Digital Fire Contro Systeml; gun location, pointing,
navigation, digital communications
One turn of the elevation ranges for the m777a2? - (ANSWER)10 mils
What is the elevation ranges for m77a2 - (ANSWER)-43 mils to +1275 mils
What are the rates of fire for the m777a2? - (ANSWER)4 rounds/min every 2 mins
2 rounds/min determined by the TWD
What is the traversing range of the m777a2? - (ANSWER)400 left 400 right
What is the weight of the m777a2? - (ANSWER)w 9887
w/o 9277
Section drill must be conducted in ______, except for commands and report. - (ANSWER)Silence
When looking at the oil index pin, if the pin is not flush, what condition exists? - (ANSWER)Low oil
, M777A2 HOWITZER QUESTIONS AND ANSWERS 2026 WITH COMPLETE SOLUTION.
The scavenge isolator valve must be ____ when working around the breech. Failure to ______ the valve
could result in inadvertent breech motion. - (ANSWER)Close
Do not open ____ on prime mover when howitzer is attached, damage may occur to the muzzle brake
and lunnette assembly. - (ANSWER)Tail gate
The combined weight of the spade trail arm and blade is ____ and must be supported by a minimum of
two personnel. - (ANSWER)204lbs
Remain at least ___ feet from transmitting antenna of howitzer mounted radios. - (ANSWER)2
Suspension levers must be operated simultaneously. The howitzer cannot be lowered until the following
steps have been completed: - (ANSWER)•Handbrakes are applied, •Lunette is unhooked from prime
mover, •Cannon is supported by minimum of two personnel, •Stabilizers have been deployed
When laying the howitzer with the M2 Aiming Circle, the cross hairs must be +/- ____ mils before the
Gunner commands "READY, DROP" - (ANSWER)10
How deep must the spades be dug in when emplacing the howitzer? - (ANSWER)3 inched indirect, 6
inches direct
The loading tray can only be operated when the ____. - (ANSWER)breech is open
Emplaced distances away from weapon will vary due to type of terrain but must be between ____. The
M1A2 collimator should not be emplaced more than 4.4yds (4m) above or below the Pantel. -
(ANSWER)9-12m
What is the minimum amount of mils that must be visible on the M1A2 collimator when being layed on
the pantel? - (ANSWER)7 mils
When emplacing the aiming posts, what does a clenched fist mean? - (ANSWER)Stop
