Asbestos Supervisor Initial Exam 2026 || Most Recent Exam
2026-2027 Actual Complete Real Exam Questions And Correct
Answers (Verified Answers) Already Graded A+ | Guaranteed
Success!! | Newest Exam |Just Released!!
A removal area is 100 feet long and 50 feet wide with a ten foot
ceiling. What is
the volume of the area? - ANSWER -50,000
cubic feet
Assuming a negative air filtration unit pulls 2,000 cubic feet
per minute, how
many units would be required to maintain sufficient negative
pressure in the
above area? (add one extra unit as back-up) -
ANSWER -3
The Federal Agency responsible for the enforcement of
environmental regulation is: - ANSWER -Occupational Safety
and Health Administration
(OSHA)
One method of reducing electrical shock potential inside a
removal area is with
the use of: - ANSWER -Ground fault circuit
interrupters (GFCI)
, Visual inspection of an abatement project should take place: -
ANSWER -When
final cleaning is complete and all debris is removed from
the work area
The maximum temperature of pipes where global removal
is allowed is: -
ANSWER -150
degree F
What areas into a regulated area are required by OSHA to
be posted? -
ANSWER -All Entrance
and Exit
According to NYS Rule Code 56-7.11, all seams between
adjacent layers shall
be staggered by a distance of at least: - ANSWER
-24 inches
What is the maximum length of the negative air exhaust
duct per ICR 56 -
ANSWER -25
FT
Given the protection factor for a full face respirator is 50, the
fiber concentration
2026-2027 Actual Complete Real Exam Questions And Correct
Answers (Verified Answers) Already Graded A+ | Guaranteed
Success!! | Newest Exam |Just Released!!
A removal area is 100 feet long and 50 feet wide with a ten foot
ceiling. What is
the volume of the area? - ANSWER -50,000
cubic feet
Assuming a negative air filtration unit pulls 2,000 cubic feet
per minute, how
many units would be required to maintain sufficient negative
pressure in the
above area? (add one extra unit as back-up) -
ANSWER -3
The Federal Agency responsible for the enforcement of
environmental regulation is: - ANSWER -Occupational Safety
and Health Administration
(OSHA)
One method of reducing electrical shock potential inside a
removal area is with
the use of: - ANSWER -Ground fault circuit
interrupters (GFCI)
, Visual inspection of an abatement project should take place: -
ANSWER -When
final cleaning is complete and all debris is removed from
the work area
The maximum temperature of pipes where global removal
is allowed is: -
ANSWER -150
degree F
What areas into a regulated area are required by OSHA to
be posted? -
ANSWER -All Entrance
and Exit
According to NYS Rule Code 56-7.11, all seams between
adjacent layers shall
be staggered by a distance of at least: - ANSWER
-24 inches
What is the maximum length of the negative air exhaust
duct per ICR 56 -
ANSWER -25
FT
Given the protection factor for a full face respirator is 50, the
fiber concentration
