ASE G1 Test Prep (General Automobile Maintenance)|
ASE A1 (Engine Repair) Prac ce Test – Cumula ve|
COMBINED With complete solu on| Updated RATED A+
| NEW | 2026
True
Toe can cause re wear if not within manufacturer's specifica ons
(True or False)
True
Camber can cause re wear if not within manufacturer's specifica ons
(True or False)
False
Caster can cause re wear if not within manufacturer's specifica ons
(True or False)
Technician A only
Technician A says that a PAX run-flat re uses a special wheel.
Technician B says that a standard re can be used to replace a PAX run-flat re.
Which technician is correct ?
Rear spacing
Wheel back spacing is also called ?
Load ra ng
A re is labeled 215/60R15 92T ; the 92 indicates what ?
The shape of the flange area
What do the le'er "J J" mean in a wheel designa on size labeled 14 x 7JJ
,Speed ra ng
A re is labeled 215/60R15 92T ; the T indicates what ?
10 mm
When purchasing replacement res, do not change re width from the stock size by more than
?
Fixed disc brake caliper
Which type of disc brake caliper may leak brake fluid more o0en ?
A Boiling Point Tester
Brake fluid boiling point can be measured using ?
Electromagne c induc on
What principle is used to create high voltage from low voltage?
The ra o of height to width
The Aspect Ra o of a re means what ?
Igni on Module
The pickup coil or trigger is usually electrically connected to the ?
Sintering
Semi-metallic brake pads are made by a process called ?
Soot is being burned
Which of these takes place during regenera on in a Diesel Par culate Filter (DPF)?
Coefficient of Fric on Ra ng
The brake pad edge code le'ers "FF" mean what ?
With the vehicle parked on level ground
Engine oil level should be checked ....
Low-Drag caliper
A quick-take-up master cylinder is required when what type of caliper design is used on a
vehicle ?
Glow plug or injector
,What part should be removed to test cylinder compression on a diesel engine?
Technician B only
Technician A says that maintenance-free ba'eries use a large amount of water.
Technician B says that maintenance-free ba'eries use materials that reduce the amount of
water used by the ba'ery.
Which technician is correct?
The Square-Cut O-ring
What part causes the disc brake caliper piston to retract when the brakes are released ?
Embi'ered
Adding a chemical to make ethylene glycol bi'er to the taste is called ?
ANSI (American Na onal Standards Ins tute)
All safety glasses should meet standards set by ?
Thro'le Posi on Sensor (TPS)
A poten ometer, a three-wire variable resistor, is used in which type of sensor?
Technician B only
Technician A says that galvanic ac vity is the result of a poor ground connec on.
Technician B says that electrolysis can occur with a poor ground connec on.
Which technician is correct?
At the outlet of the fuel rail
Where is the fuel-pressure regulator located on a vacuum-biased port fuel-injec on system?
Tendency of oil to resist flowing
Oil viscosity indicates what ?
Technician A only
Technician A says that with self-adjus ng clutch systems, the release bearing constantly
rotates.
Technician B says the ball bearing por on of the release bearing should be lubricated with high
temperature grease during rou ne maintenance.
, Which technician is correct?
30 mph
Hydroplaning can occur at speeds as low as ?
Vibra on
Ba'ery hold-down clamps or brackets help reduce ____________ , which can greatly reduce the
capacity and life of any ba'ery.
Gear reduc on
A starter can be constructed in a smaller size due to the use of ________________ and
permanent magnets.
Both Technicians A and B
Two technician are discussing the need for history of the vehicle. Technician A says that an
accident could cause faults due to hidden damage.
Technician B says that some faults could be related to a previous repair.
Which technician is correct?
Both Technicians A and B
Technician A says the gear reduc on occurs when the drive gear turns faster than the driven
gear.
Technician B says that overdrive occurs when the driven gear turns faster than the drive gear.
Which technician is correct?
Neither Technician A nor B
Technician A says that the cooling system should be tested for leaks using a pressure-operated
pressure pump.
Technician B says that the freezing and boiling point of the coolant can be tested using a
thermometer.
Which technician is correct?
Technician B only
Technician A says that a wye-wound stator produces more maximum output than the same
alternator equipped with a delta-wound stator.
ASE A1 (Engine Repair) Prac ce Test – Cumula ve|
COMBINED With complete solu on| Updated RATED A+
| NEW | 2026
True
Toe can cause re wear if not within manufacturer's specifica ons
(True or False)
True
Camber can cause re wear if not within manufacturer's specifica ons
(True or False)
False
Caster can cause re wear if not within manufacturer's specifica ons
(True or False)
Technician A only
Technician A says that a PAX run-flat re uses a special wheel.
Technician B says that a standard re can be used to replace a PAX run-flat re.
Which technician is correct ?
Rear spacing
Wheel back spacing is also called ?
Load ra ng
A re is labeled 215/60R15 92T ; the 92 indicates what ?
The shape of the flange area
What do the le'er "J J" mean in a wheel designa on size labeled 14 x 7JJ
,Speed ra ng
A re is labeled 215/60R15 92T ; the T indicates what ?
10 mm
When purchasing replacement res, do not change re width from the stock size by more than
?
Fixed disc brake caliper
Which type of disc brake caliper may leak brake fluid more o0en ?
A Boiling Point Tester
Brake fluid boiling point can be measured using ?
Electromagne c induc on
What principle is used to create high voltage from low voltage?
The ra o of height to width
The Aspect Ra o of a re means what ?
Igni on Module
The pickup coil or trigger is usually electrically connected to the ?
Sintering
Semi-metallic brake pads are made by a process called ?
Soot is being burned
Which of these takes place during regenera on in a Diesel Par culate Filter (DPF)?
Coefficient of Fric on Ra ng
The brake pad edge code le'ers "FF" mean what ?
With the vehicle parked on level ground
Engine oil level should be checked ....
Low-Drag caliper
A quick-take-up master cylinder is required when what type of caliper design is used on a
vehicle ?
Glow plug or injector
,What part should be removed to test cylinder compression on a diesel engine?
Technician B only
Technician A says that maintenance-free ba'eries use a large amount of water.
Technician B says that maintenance-free ba'eries use materials that reduce the amount of
water used by the ba'ery.
Which technician is correct?
The Square-Cut O-ring
What part causes the disc brake caliper piston to retract when the brakes are released ?
Embi'ered
Adding a chemical to make ethylene glycol bi'er to the taste is called ?
ANSI (American Na onal Standards Ins tute)
All safety glasses should meet standards set by ?
Thro'le Posi on Sensor (TPS)
A poten ometer, a three-wire variable resistor, is used in which type of sensor?
Technician B only
Technician A says that galvanic ac vity is the result of a poor ground connec on.
Technician B says that electrolysis can occur with a poor ground connec on.
Which technician is correct?
At the outlet of the fuel rail
Where is the fuel-pressure regulator located on a vacuum-biased port fuel-injec on system?
Tendency of oil to resist flowing
Oil viscosity indicates what ?
Technician A only
Technician A says that with self-adjus ng clutch systems, the release bearing constantly
rotates.
Technician B says the ball bearing por on of the release bearing should be lubricated with high
temperature grease during rou ne maintenance.
, Which technician is correct?
30 mph
Hydroplaning can occur at speeds as low as ?
Vibra on
Ba'ery hold-down clamps or brackets help reduce ____________ , which can greatly reduce the
capacity and life of any ba'ery.
Gear reduc on
A starter can be constructed in a smaller size due to the use of ________________ and
permanent magnets.
Both Technicians A and B
Two technician are discussing the need for history of the vehicle. Technician A says that an
accident could cause faults due to hidden damage.
Technician B says that some faults could be related to a previous repair.
Which technician is correct?
Both Technicians A and B
Technician A says the gear reduc on occurs when the drive gear turns faster than the driven
gear.
Technician B says that overdrive occurs when the driven gear turns faster than the drive gear.
Which technician is correct?
Neither Technician A nor B
Technician A says that the cooling system should be tested for leaks using a pressure-operated
pressure pump.
Technician B says that the freezing and boiling point of the coolant can be tested using a
thermometer.
Which technician is correct?
Technician B only
Technician A says that a wye-wound stator produces more maximum output than the same
alternator equipped with a delta-wound stator.
