The selection of a cutting torch tip depends on the thickness of the base metal being
cut and the _____.
Give this one a try later!
type of fuel gas being used
When an empty cylinder has been removed from the workstation and stored, it must
be marked MT (or the acceptable site notation for indicating an empty cylinder) _____.
Give this one a try later!
near its top
, The special cutting tip for cutting off bolt heads and nuts is called a _____.
Give this one a try later!
rivet cutting tip
Gouging operations use a special tip that produces a low-velocity stream of oxygen
that _____.
Give this one a try later!
curves upward
The process of cutting a groove into a surface is known as _____.
Give this one a try later!
gouging
When cutting thin steel with oxyfuel cutting equipment, point the torch tip in the
direction the torch is traveling at a _____.
Give this one a try later!
15- to 20-degree angle
cut and the _____.
Give this one a try later!
type of fuel gas being used
When an empty cylinder has been removed from the workstation and stored, it must
be marked MT (or the acceptable site notation for indicating an empty cylinder) _____.
Give this one a try later!
near its top
, The special cutting tip for cutting off bolt heads and nuts is called a _____.
Give this one a try later!
rivet cutting tip
Gouging operations use a special tip that produces a low-velocity stream of oxygen
that _____.
Give this one a try later!
curves upward
The process of cutting a groove into a surface is known as _____.
Give this one a try later!
gouging
When cutting thin steel with oxyfuel cutting equipment, point the torch tip in the
direction the torch is traveling at a _____.
Give this one a try later!
15- to 20-degree angle
