When the cut is rough and slag accumulates on the bottom edge, the likely cause is:
Give this one a try later!
Using a dirty tip
When piercing holes in a plate you should:
Give this one a try later!
Raise the tip when the cutting lever is depressed
, If a shop were to switch from acetylene to propane gas for cutting, it would be
necessary to:
Give this one a try later!
Check with the manufacturer to determine if the equipment is compatible
Photoelectric cells and computer controls are used with __________ tracer-guided cutting
machines.
Give this one a try later!
Electronic
What tools can you use to lay out a structural shape?
(4 answers)
Give this one a try later!
Contour marker
Hammer and centre punch
Square and level
Combination square
Kerf draglines on a properly performed shape cut should be:
Give this one a try later!
Give this one a try later!
Using a dirty tip
When piercing holes in a plate you should:
Give this one a try later!
Raise the tip when the cutting lever is depressed
, If a shop were to switch from acetylene to propane gas for cutting, it would be
necessary to:
Give this one a try later!
Check with the manufacturer to determine if the equipment is compatible
Photoelectric cells and computer controls are used with __________ tracer-guided cutting
machines.
Give this one a try later!
Electronic
What tools can you use to lay out a structural shape?
(4 answers)
Give this one a try later!
Contour marker
Hammer and centre punch
Square and level
Combination square
Kerf draglines on a properly performed shape cut should be:
Give this one a try later!
