When a cutting job is completed and the oxyfuel equipment is no longer needed
Give this one a try later!
the first step in shutting down the oxyfuel cutting equipment is to close the
fuel gas cylinder valve.
Before cutting or welding containers
Give this one a try later!
purge them with a flow of inert gas.
When welding wear
, Give this one a try later!
high-top safety boots at least 8" tall.
A track burner is a
Give this one a try later!
device used to cut or bevel a straight line
When acetylene gas is combined with oxygen during oxyfuel cutting activities, the
acetylene causes the flame to burn hotter than
Give this one a try later!
5,500F
The selection of a cutting torch tip depends on the
Give this one a try later!
thickness of the base metal being cut and the kind of fuel gas being used.
A cutting flame that has an excess of oxygen is called an
Give this one a try later!
Give this one a try later!
the first step in shutting down the oxyfuel cutting equipment is to close the
fuel gas cylinder valve.
Before cutting or welding containers
Give this one a try later!
purge them with a flow of inert gas.
When welding wear
, Give this one a try later!
high-top safety boots at least 8" tall.
A track burner is a
Give this one a try later!
device used to cut or bevel a straight line
When acetylene gas is combined with oxygen during oxyfuel cutting activities, the
acetylene causes the flame to burn hotter than
Give this one a try later!
5,500F
The selection of a cutting torch tip depends on the
Give this one a try later!
thickness of the base metal being cut and the kind of fuel gas being used.
A cutting flame that has an excess of oxygen is called an
Give this one a try later!
