The hoses used to carry oxygen from the cylinder to the torch are usually _____.
a. red
b. blue
c. green
d. orange
Give this one a try later!
c. green
The oxidation that occurs during an oxy-fuel cutting operation is similar to a greatly
sped-up _____.
a. tempering process
b. annealing process
, c. rusting process
d. crystallizing process
Give this one a try later!
c. rusting process
How should gas cylinders be transported to a workstation?
a. Carried by hand with one worker on each end of the cylinder
b. Lying flat in a cylinder cart or truck
c. Rolled carefully by a qualified worker from the storage area
d. In an upright position on a hand truck or bottle cart
Give this one a try later!
d. In an upright position on a hand truck or bottle cart
When cutting thin steel with oxyfuel cutting equipment, point the torch tip in the
direction the torch is
traveling at a _____.
a. 10- to 12-degree angle
b. 15- to 20-degree angle
c. 21- to 25-degree angle
d. 30- to 35-degree angle
Give this one a try later!
b. 15- to 20-degree angle
a. red
b. blue
c. green
d. orange
Give this one a try later!
c. green
The oxidation that occurs during an oxy-fuel cutting operation is similar to a greatly
sped-up _____.
a. tempering process
b. annealing process
, c. rusting process
d. crystallizing process
Give this one a try later!
c. rusting process
How should gas cylinders be transported to a workstation?
a. Carried by hand with one worker on each end of the cylinder
b. Lying flat in a cylinder cart or truck
c. Rolled carefully by a qualified worker from the storage area
d. In an upright position on a hand truck or bottle cart
Give this one a try later!
d. In an upright position on a hand truck or bottle cart
When cutting thin steel with oxyfuel cutting equipment, point the torch tip in the
direction the torch is
traveling at a _____.
a. 10- to 12-degree angle
b. 15- to 20-degree angle
c. 21- to 25-degree angle
d. 30- to 35-degree angle
Give this one a try later!
b. 15- to 20-degree angle
