NFPA 1002 - PUMP OPS EXAM QUESTIONS WITH VERIFIED ANSWERS LATEST UPDATE 2026

NFPA 1002 - PUMP OPS EXAM QUESTIONS WITH VERIFIED ANSWERS LATEST UPDATE 2026 What is the primary function of the fire department pumper? A. Transport water to areas beyond a water system. B. Suppress flammable liquid fires and spill vapours at airports. C. Provide water at an adequate pressure for fire streams. D. Possess the ability to pump and roll. - Answers C. Provide water at an adequate pressure for fire streams. Which legislation allows for the establishment of a fire service in Ontario? A. Highway Traffic Act (HTA) B. National Fire Protection Association (NFPA) C. Fire Protection and Prevention Act (FPPA) D. Occupational Health and Safety Act (OHSA) - Answers C. Fire Protection and Prevention Act (FPPA) How does NFPA 1500 increase safety for fire apparatus design? A. Allows seat belts to be optional in an enclosed cab. B. States that firefighters must wear helmets in an enclosed cab. C. Requires all members be seated in an enclosed cab. D. Mandates that SCBA must be donned in an enclosed cab. - Answers C. Requires all members be seated in an enclosed cab. If downed power lines block access to the water supply, which agency is responsible for mitigating the hazard? A. Ontario One Call. B. Fire departments. C. Utility Company. D. Electrical Safety Authority (ESA). - Answers C. Utility Company How is an annual capacity check performed? A. From on-board tank B. From a static source C. From a relay D. From a pressurized source - Answers B. From a static source What is the maximum allowable amount of excess play on a steering wheel? A. 10 degrees in either direction B. 25 degrees in either direction C. 20 degrees in either direction D. 15 degrees in either direction - Answers A. 10 degrees in either direction During a pre-trip inspection, the pump operator discovers a leak in the air brake system. What is the first step to remedy the situation? A. Monitor the truck until the shift is done. B. Keep truck running to maintain pressure. C. Take truck out of service. D. Fix slack adjuster. - Answers C. Take truck out of service. During a pre-trip inspection, a pump operator discovers a pike pole is missing from the vehicle inventory. What is done? A. Leave the issue for the next shift. B. Report it to the company officer. C. Remove it from inventory. D. Borrow it from another apparatus. - Answers B. Report it to the company officer. When testing the priming system, the pump fails to achieve -75kpa during the test. What does the operator do? A. Remove the apparatus from service. B. Confirm water tank is empty. C. Check the engine oil level. D. Decrease the engine's rpm. - Answers A. Remove the apparatus from service. In conjunction with PPE, what class of safety vest is required to be worn at a highway incident? A. Class 3 B. Class 4 C. Class 2 D. Class 1 - Answers C. Class 2 When backing up fire apparatus, what must be in place? A. Spotters B. Wheel C. Sirens D. Windows closed - Answers A. Spotters When the apparatus is in motion, the driver notices a firefighter in the back has taken off their seatbelt to put on an SCBA. What is done? A. Slow down and stop until firefighter is secured by a seat belt B. Stop apparatus and return to station C. Continue to scene and talk to firefighter later D. Speed up and tell firefighter to put on seat belt - Answers A. Slow down and stop until firefighter is secured by a seat belt When responding to an emergency incident, how does the fire apparatus driver/operator respond at an intersection with a red light? A. Leave sirens on, bring apparatus to a stop, and proceed with caution. B. Leave sirens off, slow down, and proceed with caution. C. Turn on sirens, increase speed and enter intersection. D. Turn off sirens, slow down, and proceed with caution. - Answers A. Leave sirens on, bring apparatus to a stop, and proceed with caution. What is the collapse zone of a building? A. 1 1/2 times the height of the structure. B. 2 times the height of the structure. C. Half the height of the structure. D. The height of the structure. - Answers A. 1 1/2 times the height of the structure. What is a definition of a dump site? A. Where damaged equipment is disposed of. B. Where the tanker can off-load the water. C. Where all gear is staged. D. Where aerial apparatus sets up. - Answers B. Where the tanker can off-load the water. Why is wind direction a factor when positioning a fire apparatus? A. Ensures pump operator protected from elements. B. Protects pump operator from smoke. C. Allows pump operator to remain in apparatus. D. Keeps the engine from going to high idles. - Answers B. Protects pump operator from smoke. The fire department connection in front of the high rise is vandalized. How does the pump operator charge the standpipe system? A. Have building superintendent call for service. B. Charge the first floor standpipe connection. C. Call works department for a water truck. D. Ask the water department to repair connection. - Answers B. Charge the first floor standpipe connection. An apparatus and crew arrive on scene at a single family dwelling, and there are evident fire conditions. Where does the pump operator locate the apparatus? A. At position that offers tactical advantage. B. Away from the pedestrian walkway. C. Beside the main entrance. D. In front of the closest hydrant. - Answers A. At position that offers tactical advantage. Which type of pump is used as a priming pump? A. Piston B. Rotary valve C. Centrifugal. D. Rotary gear. - Answers D. Rotary Gear Where is the advantage of stopping apparatus short of the hydrant? A. Facilitates adequate traffic flow. B. Does not require the use of a hose clamp. C. Allows the hose to curve preventing kinks. D. Reduces the congestion around water supply. - Answers C. Allows the hose to curve preventing kinks. When drafting, how does the pump operator recognize that the strainer is becoming blocked? A. Pressure gauge decreases in pressure. B. Compound gauge decreases in pressure. C. Pressure gauge increases in vacuum. D. Compound gauge increases in vacuum. - Answers D. Compound gauge increases in vacuum. While operating a 6,000 l/min pump, what is the maximum amount of time allowed to achieve prime? A. 15 seconds B. 60 seconds C. 45 seconds D. 30 seconds - Answers C. 45 seconds What is a hydrant with the largest capacity connected to? A. Distributor main B. Primary feeder C. Dead-end main D. Secondary feeder - Answers B. Primary feeder What is the formula .067dxNP used to estimate? A. Nozzle reaction for straight-tip nozzles. B. Flow of water in litres-per-minute for a solid stream nozzle. C. Velocity of water in meters-per-minute. D. Nozzle reaction for fog nozzles. - Answers B. Flow of water in litres-per-minute for a solid stream nozzle. What nozzle reaction does a 32mm tip with 350kpa nozzle pressure produce? A. 460 N B. 538 N C. 40 N D. 500 N - Answers B. 538 N How is the transition made from the water tank to the external water supply? A. Switching from pressure to rpm mode B. Disconnecting the external supply C. Changing smoothly without interrupting the fire attack D. Placing the apparatus in pump gear - Answers C. Changing smoothly without interrupting the fire attack When attack lines are used intermittently during pump operations, how does a pump operator ensure the pump does not overheat? A. Engage apparatus high idle B. Close the tank fill valve C. Open the pump bypass valve D. Release the auxiliary cooling valve - Answers C. Open the pump bypass valve For drafting purposes, how is lift measured? A. From the surface of the water to the pump discharge. B. From the surface of the water to the pump intake. C. From the bottom of the strainer to the top of the pump. D. From the bottom of the strainer to the center of the pump. - Answers B. From the surface of the water to the pump intake.