STATE BRAKE CERTIFICATION (2026) EXAM
QUESTIONS AND ALL CORRECT ANSWERS
100% SOLVED AND GUARANTEED SUCCESS!!
Save
Terms in this set (33)
A cracked or torn vacuum a hard pedal feel requiring very high pedal effort
diaphragm in a brake power to stop
booster would most likely cause:
to test a vacuum power brake drop slightly and remain firm
booster in the vehicle, you should
pump the brake pedal at least 4
times, hold the brake pedal
depressed, and start the engine. the
brake pedal should:
A mechanic finds gear lube inside a plugged axle
both rear drums on a rear wheel
drive vehicle. What is most likely the
cause of this problem?
The rear brakes are dragging after technician use the parking brake to adjust shoes
having new linings installed and the and the cable is stuck
drums machined. the most likely
cause is the:
, While test driving a car, the brake fluid or grease on the brake linings
mechanic finds that the right front
brake "grabs". The most likely cause
of this problem is:
Which of the following incorrect master cylinder push rod adjusted too long
service procedures will cause brake
lock-up?
Which of the following incorrect incorrect run-out on the car brake lathe
service procedures could cause
brake pedal pulsation?
A common cause of pedal NOT caused by improperly torqued wheels,
pulsation during brake application damaged backing plates, or lubricated shims
is:
A properly functioning load sensing cause an increase in the hydraulic pressure
proportioning valve will: during braking at the rear wheel cylinders when
the vehicle is loaded.
which of the following is a quick pump up the brake pedal, then hold it firm. if the
way to isolated a defective master pedal slowly drops to the floor, the master
cylinder? There are no external cylinder may be defective.
leaks in the system.
After rebuilding a master cylinder, adjusted properly
the rod between the master
cylinder and booster should be:
Upon inspecting brake fluid silicone fluid added to the system
condition, the technician observes
the diaphragm in the master
cylinder cup is swollen. Which of
the following is the most likely
cause?
QUESTIONS AND ALL CORRECT ANSWERS
100% SOLVED AND GUARANTEED SUCCESS!!
Save
Terms in this set (33)
A cracked or torn vacuum a hard pedal feel requiring very high pedal effort
diaphragm in a brake power to stop
booster would most likely cause:
to test a vacuum power brake drop slightly and remain firm
booster in the vehicle, you should
pump the brake pedal at least 4
times, hold the brake pedal
depressed, and start the engine. the
brake pedal should:
A mechanic finds gear lube inside a plugged axle
both rear drums on a rear wheel
drive vehicle. What is most likely the
cause of this problem?
The rear brakes are dragging after technician use the parking brake to adjust shoes
having new linings installed and the and the cable is stuck
drums machined. the most likely
cause is the:
, While test driving a car, the brake fluid or grease on the brake linings
mechanic finds that the right front
brake "grabs". The most likely cause
of this problem is:
Which of the following incorrect master cylinder push rod adjusted too long
service procedures will cause brake
lock-up?
Which of the following incorrect incorrect run-out on the car brake lathe
service procedures could cause
brake pedal pulsation?
A common cause of pedal NOT caused by improperly torqued wheels,
pulsation during brake application damaged backing plates, or lubricated shims
is:
A properly functioning load sensing cause an increase in the hydraulic pressure
proportioning valve will: during braking at the rear wheel cylinders when
the vehicle is loaded.
which of the following is a quick pump up the brake pedal, then hold it firm. if the
way to isolated a defective master pedal slowly drops to the floor, the master
cylinder? There are no external cylinder may be defective.
leaks in the system.
After rebuilding a master cylinder, adjusted properly
the rod between the master
cylinder and booster should be:
Upon inspecting brake fluid silicone fluid added to the system
condition, the technician observes
the diaphragm in the master
cylinder cup is swollen. Which of
the following is the most likely
cause?
